Low Temperature Superplasticity and Intragranular Misorientation in Severely Rolled Sheets of Al-4.5%Mg-0.7%Mn Based Alloys

Yoshimasa Takayama; H. Ochiai; Norio Furushiro; Hajime Kato; Hideo Watanabe

doi:10.4028/www.scientific.net/MSF.551-552.601

Paper Titles

Gas Pressure Forming of Amorphous Fe₇₈Si₉B₁₃ Alloy
p.575

Application of High-Strain-Rate Superplastic Zn-Al Alloy to Seismic Dampers and its Optimised Shape Design
p.583

Low Temperature Superplasticity of Titanium Alloy Processed by Thermohydrogen Treatment
p.591

Superplastic Flow of Silicon Nitride-Based Nanocomposite at High Strain Rates
p.597

Low Temperature Superplasticity and Intragranular Misorientation in Severely Rolled Sheets of Al-4.5%Mg-0.7%Mn Based Alloys
p.601

Superplasticity of Nanostructured Nickel Alloy and Composite Fabricated by Electrodeposition
p.607

High Resolution Surface Studies of Superplastic Deformation
p.615

Cavitation Behavior of Ultra-Fine Grained Ti-6Al-4V Alloy Produced by Equal-Channel Angular Pressing
p.621

The Effect of Strain Rate History on the Dynamic Grain Growth Behaviour of AA 5083
p.627

HomeMaterials Science ForumMaterials Science Forum Vols. 551-552Low Temperature Superplasticity and Intragranular...

Low Temperature Superplasticity and Intragranular Misorientation in Severely Rolled Sheets of Al-4.5%Mg-0.7%Mn Based Alloys

Abstract:

Severely rolled sheets of Al-4.5%Mg-0.7%Mn based alloys have been prepared to achieve grain refinement leading to low temperature superplasticity. Rolling is one of straining technique which has a high possibility of industrial application. The alloys used were T1: base one adding 0.08%Zr and 0.05Ti for suppression of grain growth, F1: 0.80%Fe addition and F2: 1.92%Fe addition to increase nucleation sites of recrystallization. For comparison, M1: Al-4.2%Mg was also prepared. All of samples were 99.8% cold rolled to thin sheet 0.1mm thick. The maximum elongation of 150%, which was markedly large in consideration of specimen thickness of 0.1mm, was obtained at 533K and 1.4×10-3s-1 for T1 sample while the elongations for F1 and F2 showed less than 100%. On the other hand, M1 exhibited larger elongation of 190% at 533K and 1.4×10-3s-1. Further, difference in superplastic deformation of these alloys was investigated by using SEM/ EBSP analysis of intragranular misorientation, which reflects strain or stored energy generated during deformation with dislocation glide, to discuss the deformation mechanism.