Ti/Al2O3 and Ni/Al2O3 Laminates Prepared by Plasma Activated Sintering (PAS)

Jian Ping Lin; Guan Jun Qiao; Hai Yun Jin; Ya Jie Guo; Tian Jian Lu

doi:10.4028/www.scientific.net/KEM.368-372.1831

Paper Titles

A Stepwise Control Route for the Preparation of Mg-Al, Zn-Al, and Mg-Fe Layered Double Hydroxides (LDHs)
p.1820

Fabrication of ZrO₂-SUS Functionally Graded Materials by Slip Casting
p.1823

Preparation of Nano-Laminated Composite by Electrophoretic Deposition
p.1825

Preparation of Glass-Alumina Functionally Gradient Materials by Rapid Prototyping Technology
p.1828

Ti/Al₂O₃ and Ni/Al₂O₃ Laminates Prepared by Plasma Activated Sintering (PAS)
p.1831

TiN/Al₂O₃ Functionally Graded Material Fabricated by In Situ Reaction
p.1835

Corrosion Protection of Stainless Steel by ZrO₂-CeO₂ Sol-Gel Coatings
p.1838

Fabrication of SiC Dense-Porous Laminates by Electrophoretic Deposition Process
p.1841

Effect of Silicon Carbide Interlayers on the Mechanical Behavior of T800-HB-Fiber-Reinforced Silicon Carbide-Matrix Composites
p.1844

HomeKey Engineering MaterialsKey Engineering Materials Vols. 368-372Ti/Al2O3 and Ni/Al2O3 Laminates Prepared by Plasma...

Ti/Al₂O₃ and Ni/Al₂O₃ Laminates Prepared by Plasma Activated Sintering (PAS)

Abstract:

In this research, the metal and ceramic laminates Ti/Al2O3, Ni/Al2O3 were prepared by PAS. The bonding interfaces of Ti/Al2O3, Ni/Al2O3 were observed and analyzed. The microstructures of laminates were observed by SEM. It was shown that the joints of the samples were tight and had not visible flaws. Moreover, the comparison of Ti/Al2O3 and Ni/Al2O3 laminates showed that the join mechanisms of them were different. Ni/Al2O3 laminates that had not apparent conversion zone were joined by diffusion and had lower bond strength. Ti/Al2O3 laminates have obvious conversion zone because Ti and oxygen have strong combining power. Three-point bending test indicated that the fracture of laminates was correlated to the bond strength of the interface.