Paper Title:
Investigation of the Milling Performance about 7050-T7451 Aluminum Alloy Based on Orthogonal Experiment
  Abstract

The high-speed milling process has been widely used for manufacturing the aeronautical aluminum alloys. And it is quite important to choose the logical milling parameters for improving the precision and surface quality in the high-speed milling aluminum alloys. In this paper, the orthogonal experiments are designed and made to construct the relationships between the milling force and milling factors to 7050-T7541 aluminum alloys. The milling factors are mainly consist of the milling speed, the feed rate, the milling depth and the milling width. The empirical formulas of milling force are derived by multiple linear regression analysis, and the formulas are tested to be correct by the single factor experiment. The research is very important for further study of the aluminum alloys.

  Info
Periodical
Chapter
Chapter 3: Advanced Manufacturing Technology (1)
Edited by
Dongye Sun, Wen-Pei Sung and Ran Chen
Pages
1431-1435
DOI
10.4028/www.scientific.net/AMM.121-126.1431
Citation
K. Y. Tang, L. H. Zhou, L. Song, "Investigation of the Milling Performance about 7050-T7451 Aluminum Alloy Based on Orthogonal Experiment", Applied Mechanics and Materials, Vols. 121-126, pp. 1431-1435, 2012
Online since
October 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Yan Cong Li, Yan Shen Xu, Lian Hong Zhang
Abstract:Based on characteristic of stainless steel material, its milling performance is analyzed. Milling force of 1Cr18Ni9Ti stainless steel was...
577
Authors: Ke Yan Tang, Li Hua Zhou, Li Song
Abstract:The milling process has been widely used for manufacturing aeronautical materials. It is very important to choose the reasonable milling...
2867
Authors: Xue Hui Wang, Ming Jun Feng, Can Zhao
Abstract:The mechanical properties of flat end mill is analyzed the high-speed milling, the linear model for milling force is established. And the...
254
Authors: Yue Feng Yuan, Wen Ying Zhang, Xing Chang
Chapter 6: New Materials and Advanced Materials
Abstract:Cutting force experiments in turning aluminum-silicon alloy ZL104 are carried out with cement carbide tool YG8. The influence of cutting...
971
Authors: K.P. Zhang, Cheng Yong Wang, Ying Ning Hu, Yue Xian Song
I. Material Subtractive Processes: Cutting and Non-Traditional Processes
Abstract:7CrSiMnMoV (HRC65) hardened steel mold was cutted to investigate the effects of cutting parameters (cutting speed, feed speed, radial cutting...
32