Experimental Study on a Micro-Scale Shaft Grinding Tool |
|
| Journal | Applied Mechanics and Materials (Volumes 121 - 126) |
|---|---|
| Volume | Frontiers of Manufacturing and Design Science II |
| Edited by | Dongye Sun, Wen-Pei Sung and Ran Chen |
| Pages | 157-161 |
| DOI | 10.4028/www.scientific.net/AMM.121-126.157 |
| Citation | Jun Cheng et al., 2011, Applied Mechanics and Materials, 121-126, 157 |
| Online since | October, 2011 |
| Authors | Jun Cheng, Ya Dong Gong, Yue Ming Liu, Jian Yu Yang |
| Keywords | Experimental Study, Micro Grinding, Tool Fabrication |
| Abstract | This paper presents a novel micro shaft grinding tool is fabricated by cold sprayed with CBN grains, and a micro-grinding experiment is carried out to study micro grinding principle of the fabricated tools. The manufacturing is carried out on a desktop micro machine developed by NEU. Influences caused by particle size on surface quality has been discussed, it has been tested that low surface roughness could be achieved on 3000 particle size of micro shaft grinding tool, the roughness accomplished in the experiment is about 0.086μm. |
| Full Paper | 
Get the full paper by clicking here
|
First page example
