Paper Title:
Research on Cutting Remanufacture Hardness Deposited Materials in the Impactive Condition
  Abstract

High performance cemented carbide YG610 was adopted for remanufacture hardness deposited materials cutting experiment. The experiment results showed that the same conclusions can be drawn from two group orthogonal experiments. The influence order on cutting capability of cutting tools was: feed rate﹥cutting speed﹥ cutting depth. The cutting length of cutting tools increases monotonously with the feed rate decrease. And the effects by the cutting depth were comparatively small, which is almost negligible in hardness materials cutting. Therefore,low feed rate and large depth of cut are beneficial to keep cutting capability of cutting tools and improve manufacturing productivity. By the results of two orthogonal experiments and extreme deviation analysis, the optimal scheme for cutting parameters were achieved after calculating the best level of the factor.

  Info
Periodical
Edited by
Yi-Min Deng, Aibing Yu, Weihua Li and Di Zheng
Pages
998-1001
DOI
10.4028/www.scientific.net/AMM.37-38.998
Citation
Z. Y. Wu, X. B. Liang, X. L. Tian, S. Zhang, S. H. Wang, "Research on Cutting Remanufacture Hardness Deposited Materials in the Impactive Condition", Applied Mechanics and Materials, Vols. 37-38, pp. 998-1001, 2010
Online since
November 2010
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Hai Rong Wu, Guo Qin Huang, Xipeng Xu
Abstract:An experimental study was carried out to investigate the effects of cutting parameters on cutting force and temperature in cutting of...
559
Authors: Xue Hui Wang, Ming Jun Feng, Can Zhao
Abstract:The mechanical properties of flat end mill is analyzed the high-speed milling, the linear model for milling force is established. And the...
254
Authors: Yue Feng Yuan, Wen Ying Zhang, Xing Chang
Chapter 6: New Materials and Advanced Materials
Abstract:Cutting force experiments in turning aluminum-silicon alloy ZL104 are carried out with cement carbide tool YG8. The influence of cutting...
971
Authors: Rao T. Sadasiva, K. Satyanarayana, Y. Praneeth, Anne Venu Gopal
Chapter 15: Meso/Micro Manufacturing Equipment and Processes
Abstract:Milling is the most widely applied machining process for producing flat surfaces and prismatic shapes. To minimize the process time and...
3147
Authors: Peter Monka
Chapter 4: Advances in Tool-Chip Technology, Machining and Surface Roughness
Abstract:The paper deals with the experiments realized by means of cutting tool with linear cutting edge not parallel with the axis of the workpiece...
352