Paper Title:
Study on Surface Roughness Based on Dynamic Minimum Thickness of Cut
  Abstract

The relationship of the friction coefficient and the MTC were discussed, and the MTC and its effects on surface roughness were a theoretical analysised and experimental verification by AFM (atomic force microscope). The results show that the theoretical MTC tends to be minimal value then before the adhering effect to reach remarkable. Appropriate adjustments cutting parameters, the cutting process can always micro-cutting phase to reach the steady-thin chip, and no plowing phenomenon. So the surface residues highly were reduced and higher surface quality was achieved.

  Info
Periodical
Chapter
Chapter 1: Advanced Manufacturing Technologies
Edited by
Xingui He, Ertian Hua, Yun Lin and Xiaozhu Liu
Pages
34-37
DOI
10.4028/www.scientific.net/AMM.88-89.34
Citation
K. Ji Cai, "Study on Surface Roughness Based on Dynamic Minimum Thickness of Cut", Applied Mechanics and Materials, Vols. 88-89, pp. 34-37, Aug. 2011
Online since
August 2011
Authors
Price
US$ 28,-
Share
Authors: B.J. Xiao, Cheng Yong Wang, Ying Ning Hu, Yue Xian Song
Abstract:A two-dimensional orthogonal thermal-mechanical finite element model by Deform2D finite element analysis software is established in the...
590
Authors: Ji Cai Kuai
Chapter 3: Chemical and Biomedical Engineering
Abstract:The dynamic minimum thickness of cut for the ultra-precision machining surface quality is important influence. Between tool and the workpiece...
1246
Authors: Quan Li, Man Chen Xiong, Yin Yin Liu
Chapter 9: Materials Processing Technology and Applied Research
Abstract:Consider the mechanism of the formation of surface roughness, this paper establish the mechanical model of undeformed chip thickness caused...
770