Paper Title:
Grinding Characteristic Research of High Efficiency Deep Grinding for Viscous Material
  Abstract

Focusing on the characteristic of hard-to-grinding for viscous materials, such as titanium alloy, systemic process experiments were done about grinding viscous materials, such as TC4 titanium alloy, under the high efficiency deep grinding (HEDG). Based on the analysis to the changing and characteristic of unit area grinding force F' with maximum undeformed chip thickness hmax and equivlent cutting thickness aeq , this paper discussed the changing of its material removal mode and analyzed the changing and characteristic of grinding force ratio N, specific grinding energy es with corresponding parameters further. Then, it was analyzed about the consumption of grinding power on the process of HEDG for TC4 titanium alloy. The experiment results reveal that application of HEDG can improve machining efficiency of grinding viscous materials.

  Info
Periodical
Advanced Materials Research (Volumes 126-128)
Edited by
Yunn-Shiuan Liao, Chao-Chang A. Chen, Choung-Lii Chao and Pei-Lum Tso
Pages
88-95
DOI
10.4028/www.scientific.net/AMR.126-128.88
Citation
X. M. Sheng, L. Guo, K. Tang, H. Q. Mi, J. W. Yu, T. Chen, "Grinding Characteristic Research of High Efficiency Deep Grinding for Viscous Material", Advanced Materials Research, Vols. 126-128, pp. 88-95, 2010
Online since
August 2010
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Yi Yi Tao, Jiu Hua Xu, Wen Feng Ding
Abstract:The machining performance of porous NiTi shape memory alloys prepared using powder metallurgical production technique has been investigated...
143
Authors: Guo Qin Huang, Hei Jie Chen, Hui Huang, Xipeng Xu
Abstract:The wear of a brazed diamond wheel with diamond grits covered with brazing alloy was investigated in comparison with a traditional brazed...
125
Authors: Tadahiro Wada
Abstract:In cutting aluminum alloy 6061, continuous chips have a negative influence on the machining operation. Usually, Pb is added in order to break...
368
Authors: Yan Wei Sui, Ai Hui Liu, Bang Sheng Li, Jing Jie Guo, Wei Biao Ju
Chapter 1: Materials Properties
Abstract:Ti-6Al-4V alloy castings are made by means of induction melting technology. The relationships between grain size and tensile strength, yield...
496
Authors: Sheng Zhu, Guo Feng Han, Xiao Ming Wang, Wen Bo Du
Chapter 1: Composites
Abstract:In this study, Al-Si alloy protective coating was deposited on the surface of ZM5 magnesium alloy by cold spray technology. Researchers...
142