Paper Title:
Wear Rate Predication for Steel Based on Regression Analysis
  Abstract

The wear experimental project on contact pressure, sliding speed and surface hardness was instituted by the uniform design method, the wear properties were investigated on a vertical universal friction/wear tester, the worn surfaces of specimens were observed by scanning electron microscope (SEM). The wear rate predication model was established by polynomial regression analysis, and the goodness of fit and the significance of influencing factors was verified. The results showed that the experimental efficiency was evidently increased, and the experimental cycle was shortened by the uniform design. It is found that the wear rate predication model established is reasonable and valid, and the impact of three factors on the wear rate is coupling effect. The main wear mechanism is abrasive wear and adhesive wear.

  Info
Periodical
Advanced Materials Research (Volumes 126-128)
Edited by
Yunn-Shiuan Liao, Chao-Chang A. Chen, Choung-Lii Chao and Pei-Lum Tso
Pages
965-969
DOI
10.4028/www.scientific.net/AMR.126-128.965
Citation
Y. T. Yan, Z. L. Sun, T. Zhu, "Wear Rate Predication for Steel Based on Regression Analysis", Advanced Materials Research, Vols. 126-128, pp. 965-969, 2010
Online since
August 2010
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Bong Hwan Kim, Sang Mok Lee
Abstract:Al-Cu-Fe-B quasicrystalline and Mo coatings were obtained on the mild steel and brass substrates by thermal spraying routes for the purpose...
715
Authors: Fu Qiang Hu, Hong Zhang, Wan Sheng Zhao, Zhen Long Wang, Ding Hu, Yang Yu
Abstract:Two kinds of specimen made of a kind of Ta-W alloy material with high melting point about 3000°C were processed by a traditional EDM (TEDM)...
143
Authors: Gui Jie Liu, Xin Wang, An Jin Li
Abstract:In offshore jacket platforms, the structural steels are widely used and usually welded connected. This paper presents the welding of 45#...
263
Authors: Sui Yuan Chen, Yong Ze Yang, Jing Liang, Chang Sheng Liu
Chapter 1: Thin Films
Abstract:Anodic oxide films were prepared firstly on the surface of a 2024 aluminum alloy. Then the effect of different heat-treatment temperatures on...
132
Authors: L.H. Paijan, M.N. Berhan, M.S. Adenan, N.F.M. Yusof, E. Haruman
Chapter 4: Materials
Abstract:This paper describes the results of gaseous thermochemical treatment of nitriding duplex stainless steel using tube furnace. The nitriding...
260