Paper Title:
The Research on Cutting Force in High-Speed Milling Process of Aluminum Alloy Impeller
  Abstract

High-speed cutting process of cutting force influence variables and variation and ordinary speed cutting are obviously different, in order to study the high-speed cutting process of different parameters on the effect of cutting force, based on five axis high-speed NC machining center, using multi-factor orthogonal test method for high speed milling of aluminum alloy impeller conducted experiments. It was analyzed that cutting force influence factors of 5-axises blade machining process. A private clamp was designed and produced, to measure the cutting force of machining process. It was observe that distribution of 3-dimension cutting forces in cutting path. It was found that the distribution rule of cutting force. With the experiment study on cutting force when high speed cutting aluminum cuprum, the influence disciplinarian of each cutting parameter on cutting force was obtained.

  Info
Periodical
Edited by
Hun Guo, Zuo Dunwen, Tang Guoxing
Pages
11-15
DOI
10.4028/www.scientific.net/AMR.142.11
Citation
Y.B. Liu, C. Zhao, X. Ji, P. Zhou, "The Research on Cutting Force in High-Speed Milling Process of Aluminum Alloy Impeller", Advanced Materials Research, Vol. 142, pp. 11-15, 2011
Online since
October 2010
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Xue Dao Shu, Bao Shou Sun, Min Xiao
Modeling, Analysis and Simulation of Manufacturing Processes
Abstract:Because of unbalanced axial force of cross wedge rolling asymmetric shaft-parts causing the rolling play and not stably, it is key factors to...
589
Authors: Shu Jie Zhang, Rui Wang, Chong Qi Ma
Chapter 5: Structure, Properties and Processes of Textile Materials
Abstract:The tubular textile composite material as the liner is inversed in the pipeline by gas or water pressure, and then the damaged pipeline can...
945
Authors: Ai Jun Jiang, Kai Wu
Chapter 2: Materials Science in Computer-Aided Manufacturing and Design
Abstract:The stability model was established and the two-dimensional and three-dimensional lobes were plotted for the milling of lateral walls in...
190
Authors: Yan Kun Zhang, Xiao Hu Li, Pan Zhang
Chapter 1: High Strength High Performance Materials and New Structural System
Abstract:Based on the experiment, the splitting tensile strength and axial tensile strength of specified density steel fiber concrete are studied. The...
330
Authors: He Quan Lu, Jie Gang Mu, Shui Hua Zheng, Jin Jing Zhao, Hui Wang
Abstract:A new type of balance drum with grooves was presented, and analyzed the influence of quantity of grooves on performance of centrifugal pump...
1352