Paper Title:
Friction and Wear Properties of SiC and Immerse the Copper Graphite Against 1Cr18Ni9Ti Friction Couples
  Abstract

Friction and wear properties of SiC and immerse copper graphite(C/Cu) against stainless steel (1Cr18Ni9Ti) friction couples were studied under room temperature and unlubrication by pin-disc tribometer. The test shows that at sliding speed of 0.56ms-1 and normal load of 5N, 20N, the SiC/1Cr18Ni9Ti friction coefficient decreases. The immerse copper graphite shows good friction and wear behavior at load 50N, at which the copper of graphite matrix is transported to the surface from the pore of graphite matrix to form a couple of copper and copper. It is difficulties to measure volume loss. When load increased, the copper was transported to generate the film and was grinded away continuously, which the immerse copper graphite(C/Cu) volume loss increases at load 120N. The results of comparing two couples show volume loss of the couple SiC/1Cr18Ni9Ti is severe, so it is not suitable to combine a couple. The couple of immerse copper graphite (C/Cu)/1Cr18Ni9Ti is better applied at low load.

  Info
Periodical
Advanced Materials Research (Volumes 146-147)
Edited by
Sihai Jiao, Zhengyi Jiang and Jinglong Bu
Pages
1138-1141
DOI
10.4028/www.scientific.net/AMR.146-147.1138
Citation
X. Tian, L. D. Fang, Y. Zhu, "Friction and Wear Properties of SiC and Immerse the Copper Graphite Against 1Cr18Ni9Ti Friction Couples", Advanced Materials Research, Vols. 146-147, pp. 1138-1141, 2011
Online since
October 2010
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Jian Hua Du, Yuan Yuan Li, Xiao Hui Zheng
Micro/Nano Materials
Abstract:The Cu-based friction materials with nano-graphite were prepared through powder metallurgy technology. The microstructure and friction...
905
Authors: Jie Jiang, Dang Sheng Xiong, Jian Liang Li, Yan Shi
Abstract:Components of space machines often works at high temperature and vacuum, or on other rigour conditions, the traditional liquid lubricant...
706
Authors: Dewan Muhammad Nuruzzaman, Mohammad Asaduzzaman Chowdhury
Chapter 7: Surface Engineering
Abstract:An endeavor has been made to study and compare the friction coefficient of different polymer and composite materials. Experiments were...
590
Authors: Ting Xie, Zheng Hua Zhou, Zhen Xing Xu, Jian Wei Yu, Ming Hua Jiao
Chapter 1: Materials Engineering. Technologies and Processing
Abstract:The formed transfer film on the counterpart surface and tribological properties of PTFE composites filled with Al2O3 or...
172