Paper Title:
Linear Friction Welding of IN-718 Process Optimization and Microstructure Evolution
  Abstract

Linear Friction Welding (LFW) of IN-718 Superalloy was investigated under several processing conditions. The influence of process parameters such as frequency (60Hz to 100Hz), amplitude (2mm to 3mm) and frictional pressure (50MPa to 110MPa) on the microstructure and mechanical properties of welded specimens was determined. Optical and scanning electron microscopy, and micro-hardness testing were used to characterize the welded areas as well as the Thermo-Mechanically Affected Zones (TMAZ). In-situ thermocouple measurements were performed to follow temperature evolution in the specimens during the different phases of the LFW process. The analysis of the results indicated that for some specific conditions (f=80Hz, a=2mm and P=70MPa) a maximum temperature of 1200°C was attained during the last stage of the welding process, the burn-off phase. This temperature, very close to the alloy melting range, would be sufficient to cause partial liquation in this zone. Microscopic examinations revealed the presence of oxide particles aligned around the weld interface. Their concentration and distribution, varying with process parameters, affect the weld integrity. The TMAZ characterised by a global loss of strength (from 334HV to 250HV) is associated with temperatures exceeding 800°C and causing γ’ and γ’’ reversion. A narrow band of the TMAZ, exposed to high strains and temperatures, showed evidences of dynamic recovery and recrystallization (up to 67% of reduction in the matrix grain size). Visual and microscopic examination of the flash layer, revealed two distinct zones. Microstructure evolution and microhardness variations were associated to process parameters and the optimum conditions for obtaining defect free weldments were determined.

  Info
Periodical
Advanced Materials Research (Volumes 15-17)
Edited by
T. Chandra, K. Tsuzaki, M. Militzer and C. Ravindran
Pages
357-362
DOI
10.4028/www.scientific.net/AMR.15-17.357
Citation
C. Mary, M. Jahazi, "Linear Friction Welding of IN-718 Process Optimization and Microstructure Evolution", Advanced Materials Research, Vols. 15-17, pp. 357-362, 2007
Online since
February 2006
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Zhi Guo Chen, Zi Qiao Zheng, Dong Feng Han
Abstract:The hot deformation behaviors and microstructure in Al-Cu-Li alloy containing small amount of Ag and Mg were investigated by transmission...
1925
Authors: Tao Wang, Hong Zhen Guo, Jian Hua Zhang, Ze Kun Yao
Abstract:The microstructures and room temperature and 600°C tensile properties of Ti-5.8Al-4.0Sn-4.0Zr-0.7Nb -0.4Si-1.5Ta alloy after isothermal...
153
Authors: Xin Nan Wang, Yue Fei, Xiao Hu Zhou, Zhi Shou Zhu, Jun Li, Guo Qiang Shang, Li Wei Zhu
Abstract:The evolution regularities of microstructure and property of a new metastable β titanium alloy with different solution treatment and aging...
932
Authors: C. Shanjeevi, S. Satish Kumar, Thomas Joseph Jobin
Chapter 12: Optimization of Processing Technologies
Abstract:Friction welding is a solid state process used mostly for joining dissimilar materials due to mass production with less time consuming. The...
890
Authors: Gerald Rath, Franziska Fuchs, Norbert Enzinger
Chapter 2: Contributed Papers
Abstract:In respect of weld quality, weld strength and the heat affected zone (HAZ) size, linear friction welding (LFW) has significant advantages...
508