Paper Title:
The Steel Joint Life of the Single-Wheeled Cycle Using FEM Analysis
  Abstract

The single-wheeled cycle is fashion and convenient, but there are some problems when used, especially the joint that connect to the lead bicycle. Due to the unavoidably collision when using, there will be the cause on joint parts with high stress state of frequent change, which makes the single-wheeled cycle under security problem. In order to get it fully, this paper use the FEM software to model the single-wheeled cycle. Under the different acceleration exert, the stress state of the joint and stress distribution are researched, then recommendations given about the potential safety hazard, joint life, and the suggestions for improvement.

  Info
Periodical
Advanced Materials Research (Volumes 154-155)
Edited by
Zhengyi Jiang, Xianghua Liu and Jinglong Bu
Pages
1427-1430
DOI
10.4028/www.scientific.net/AMR.154-155.1427
Citation
H. Y. Wang, S. H. Li, L. X. Li, X. X. Zha, "The Steel Joint Life of the Single-Wheeled Cycle Using FEM Analysis", Advanced Materials Research, Vols. 154-155, pp. 1427-1430, 2011
Online since
October 2010
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Liang Chen Wu, Dong Po Wang
Chapter 15: Materials Processing Technology
Abstract:Samples of Q345 steel welded joints were tested to failure under low cycle fatigue(LCF),high cycle fatigue(HCF) and combined fatigue(CCF)...
2101
Authors: Balazs Fekete, Peter Bereczki, Peter Trampus
Session I. - Materials and Technologies
Abstract:The fatigue life of the structural materials 15H2MFA and 08H18N10T of VVER-440 reactor pressure vessel under completely reserved total strain...
47
Authors: Andrey Vlasov, Nikolay Biba, Sergey Stebunov
Chapter 8: Numerical Analysis and Modelling
Abstract:Abrasive wear and low cycle fatigue (LCF) have the greatest influence on the durability of dies. This paper presents a new criterion for...
667