Paper Title:
Simulation of Spindle Rotation Error with Three-Point Method Based on Matlab
  Abstract

This paper establishes the simulation error data models of roundness error, spindle rotation error and noise signal from the characteristics of error signal based on three-point method. From the Matlab simulation, the influence of installation angle error of the sensor, roundness error magnitude and the noise on the segregation accuracy was studied in detail. This makes up the deficiencies of previous studies, and also provides a good foundation for further improving the accuracy of three-point method.

  Info
Periodical
Advanced Materials Research (Volumes 156-157)
Edited by
Jingtao Han, Zhengyi Jiang and Sihai Jiao
Pages
1069-1073
DOI
10.4028/www.scientific.net/AMR.156-157.1069
Citation
Z. Y. Huang, W. Q. Gao, Q. S. Yan, J. J. Huang, C. T. Qing, "Simulation of Spindle Rotation Error with Three-Point Method Based on Matlab", Advanced Materials Research, Vols. 156-157, pp. 1069-1073, 2011
Online since
October 2010
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Lei Zhang, Yu Zhang, Lin Ba
Abstract:There are some applications of error separation technique in actual measurement. However there exists a series of theoretical and technical...
315
Authors: Lei Zhang, Xiu Min Yang, Lin Ba, Yu Zhang
Abstract:The measuring precision of error separation technology is directly related to error separation parameters selection. If the parameter...
421
Authors: Zhen Zhong Sun, Zeng Hong, Sheng Gui Chen
Abstract:By using homogenous coordinate transformation principle and Denavit-Hartenberg analysis method, a measurement kinematics model and a error...
263
Authors: Zi Ran Chen, Dong Lin Peng, Yong Zheng, Fang Yan Zheng, Tian Heng Zhang
Chapter 7: Computer Application in Design and Manufacturing (1)
Abstract:Due to the complexity of measurement system, it is hard correct errors by using traditional error separation and error tracing technology. To...
3850
Authors: Li Ling Huang, Fu Gui Huang
Chapter 10: Mechatronics and Control Technology
Abstract:The straightness error was measured from a certain part surface by CMM. The paper expounded the principle of error separation technique, and...
1410