Paper Title:
Study of the Method on Cutting-Force Modeling Based on the Current of High-Speed Electric Spindles
  Abstract

It is important to build the models for calculating the cutting-forces in high-speed machining, but it is difficult as the special test-bed with the cutting-force measurement system is complicated, cost much and cannot be applied directly on general machining tools. Aiming at the problems above, a new method was put forward about cutting-force modeling based on the current of high-speed electric spindles, in which the cutting-force models could be gained indirectly by analyzing the built-in motor current and the data gotten from cutting experiments on those general machining tools which are installed with electric spindles. Then on a vertical milling machine tool which is equipped with a high-speed electric spindle, a model for calculating the milling force was gotten using the method put forward by this paper. The results show that the method is simple and easy to be used in routine machine tools in plant spots and need no any special test-beds and any complicated measurement systems possessed only in the laboratory conditions.

  Info
Periodical
Advanced Materials Research (Volumes 156-157)
Edited by
Jingtao Han, Zhengyi Jiang and Sihai Jiao
Pages
517-522
DOI
10.4028/www.scientific.net/AMR.156-157.517
Citation
S. S. Li, H. W. Mao, P. Chen, X. Huang, X. Y. Chen, "Study of the Method on Cutting-Force Modeling Based on the Current of High-Speed Electric Spindles", Advanced Materials Research, Vols. 156-157, pp. 517-522, 2011
Online since
October 2010
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Ying Xue Yao, Chang Qing Liu, Jian Guang Li, H.J. Jing, S.D. Chen
Abstract:Traditional adaptive control technologies in machining process optimization are limited in applications because they depend much on sensors,...
1
Authors: S. Jiang, Yan Shen Xu, J. Wu
Abstract:To improve the cutting efficiency, one of key approaches is to control with constant force in the full depth working condition. And the...
85
Authors: Yuan Wei Wang, Song Zhang, Jian Feng Li, Tong Chao Ding
Abstract:In this paper, Taguchi method was applied to design the cutting experiments when end milling Inconel 718 with the TiAlN-TiN coated carbide...
911
Authors: Xue Hui Wang, Ming Jun Feng, Can Zhao
Abstract:The mechanical properties of flat end mill is analyzed the high-speed milling, the linear model for milling force is established. And the...
254