Paper Title:
Numerical Simulation of Plate Bender Bending Process
  Abstract

The plate’s mechanical behavior of three-roller plate bending machine had been analyzed in case of upper roller feeding based on ANSYS. Strain and stress distribution of the plate and its changes are gained. The influence of upper roller’s feeding location and bending velocity to bending process are researched. The results are valuable to bending process optimization and practical technique of plate bending.

  Info
Periodical
Advanced Materials Research (Volumes 189-193)
Edited by
Zhengyi Jiang, Shanqing Li, Jianmin Zeng, Xiaoping Liao and Daoguo Yang
Pages
2228-2232
DOI
10.4028/www.scientific.net/AMR.189-193.2228
Citation
X. J. Liu, H. S. Liu, J. Liu, H. G. Wang, "Numerical Simulation of Plate Bender Bending Process", Advanced Materials Research, Vols. 189-193, pp. 2228-2232, 2011
Online since
February 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Yi Nan Lai, Sheng Le Ren, Zeng Lou Li, Jun Tao Gu, Guang Fei Wu
Abstract:The unloading spring-back of tubes during its manufacturing process shows a strong nonlinearity, which greatly influences the precision of...
202
Authors: Qiang Li, Li Feng Fan, Ying Gao, Cong Hui Song, Wen Tao Yang
II. Solid Mechanics
Abstract:Air bending of wide-punch large radius of curvature, as a special bending mode, has been widely applied in the production of large diameter...
207
Authors: M. Mehrara, Mohammad Javad Nategh
Abstract:The bending of plates on rubber pad is a relatively new method used for roll bending of thin plates in recent years. In the present work the...
190
Authors: Ze Min Fu
Chapter 6: Frontiers of Mechanical Engineering (2)
Abstract:In this paper, the influencing factors of springback for air-bending of sheet metal are introduced. The bending springback in various process...
3602
Authors: Y X Tan, R. B. Mei, W J Wang, Y Q Liu, Z Liu, L F Huo, C S Li
Chapter 13: Materials Forming
Abstract:Front end bending often occurs in the heavy plate mills and roughing stands, which reduce productivity efficiency and the quality of the...
1952