Paper Title:
Method of Compensation Control for Shaking Table
  Abstract

This paper presents the defects existing in shaking table control including the overshoot of displacement under low-middle frequency input using three variable parameter controls, the narrow bandwidth resulting from the performance of servo-valve and low accuracy of seismic wave reproduction because of specimen and table interaction. The effects of these factors on the stability and control accuracy of shaking table are discussed, and then the reasons of these problems existing are analyzed. The aim of this paper is to improve the stability and control accuracy of shaking table, thus, some corresponding strategies for compensation control are proposed. And a series of shaking table tests with one-story frame and two-story frame for verifying the validity of compensation control algorithm are performed.

  Info
Periodical
Advanced Materials Research (Volumes 199-200)
Edited by
Jianmin Zeng, Zhengyi Jiang, Taosen Li, Daoguo Yang and Yun-Hae Kim
Pages
1397-1404
DOI
10.4028/www.scientific.net/AMR.199-200.1397
Citation
Z. B. Li, Z. Y. Tang, J. B. Ji, X. L. Li, D. X. Zhou, W. M. Yan, "Method of Compensation Control for Shaking Table", Advanced Materials Research, Vols. 199-200, pp. 1397-1404, 2011
Online since
February 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Wen Zeng, X.Z. Zhu, Z.J. Wei
Abstract:The nonlinear dynamic model of a gear-shaft-housing system is established by using finite element method (FEM). The nonlinear dynamic...
805
Authors: Huai Chao Wu, Fang Lu
Embedded System
Abstract:In order to break through the traditional flow change way of the variable plunger pump, a kind of micro-flow variable plunger pump with...
1568
Authors: Shao Jian Zhang, Suet To, Chi Fai Cheung
Abstract:This study focuses on the nonlinear dynamic characteristics of tool vibration in ultra precision diamond turning. Considering the first mode...
645
Authors: Fei Xiao, Xian Li Liu, Yan Xin Wang, Li Jia Liu, Da Qu
Chapter 2: Simulation of Machining Processes
Abstract:According to the principle of the experimental modal analysis, this study is based on tool system of the MIKRON UCP 710 numerical control...
159
Authors: Chang Zhi Lv, Ting Gao, Guo Zhi Xin, Yuan Yuan Zhou
Chapter 2: Motivation, Thermal, Electronics and Power Engineering
Abstract:In the paper, the three-phase ac motor is used as the controlled station and the FPGA device EP1C3T144C8 is adopted as the control core....
532