Surface Quality of Finishing Cut by WEDM in Gas |
|
| Journal | Advanced Materials Research (Volumes 24 - 25) |
|---|---|
| Volume | Precision Surface Finishing and Deburring Technology |
| Edited by | Hang Gao, Zhuji Jin and Yannian Rui |
| Pages | 91-96 |
| DOI | 10.4028/www.scientific.net/AMR.24-25.91 |
| Citation | Tong Wang et al., 2007, Advanced Materials Research, 24-25, 91 |
| Online since | September, 2007 |
| Authors | Tong Wang, Xin Fu Zhang, Xue Fang Zhao, M. Kunieda |
| Keywords | Finishing Cut, Straightness, WEDM in Gas |
| Abstract | This paper studies on a newly developed method, WEDM in gas, and discribes the features of finishing dry-WEDMed surface, such as narrower discharge gap length, higher surface straightness accuracy and no electrochemical etching actions. Low-speed WEDM removal rate in gas can be improved by increasing the wire winding speed. High-speed WEDM in gas has a significant advantage as high removal rate beyond the abovementioned good points, which is available for improving conventional high-speed WEDM quality. |
| Full Paper | 
Get the full paper by clicking here
|
First page example
