Paper Title:
Tool Life in High Speed Turning with Negative Rake Angle
  Abstract

The present work studies some aspects of turning process applied on mild steel using cermets tools at high speed cutting (1000mm/min) by using negative rake angle (0 to-12). The influence of increasing the cutting speed and negative rake angle on flank tool wear, cutting forces, feeding forces and tool temperature were analyzed. The research studies and concentrates on the tool life estimation and the effect of the negative rake angle and higher cutting speed on tool life. It was found that the maximum tool life is obtained in (-6) rake angle for the cutting parameters.

  Info
Periodical
Advanced Materials Research (Volumes 264-265)
Edited by
M.S.J. Hashmi, S. Mridha and S. Naher
Pages
1009-1014
DOI
10.4028/www.scientific.net/AMR.264-265.1009
Citation
E. Y. T. Adesta, M. H.F. Al Hazza, "Tool Life in High Speed Turning with Negative Rake Angle", Advanced Materials Research, Vols. 264-265, pp. 1009-1014, 2011
Online since
June 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Han Ul Lee, Dong Woo Cho
Abstract:For effective rough milling, an optimized criterion is required to select the feedrate. In this study, a method to obtain the most...
43
Authors: Yi Wan, Zhan Qiang Liu, Xing Ai
Abstract:Five-axis milling is widely used in machining of complex surfaces parts. Part quality and productivity are extremely affected by cutting...
2049
Authors: Jun Zhou, Jian Feng Li, Jie Sun
Abstract:In this paper, the micro-scale machining characteristics of a non-ferrous structural alloy, aluminum 7050-T7451 is investigated through a...
657
Authors: Atanu Das, Partha Pratim Saha, Santanu Das
Chapter 8: Material Processing Technology
Abstract:Shaping Burrs are produced at the edge of a workpiece when a cutter exits it. It causes difficulties in manufacturing and assembly stages....
1602
Authors: A.K.M. Nurul Amin, Siti Aminatuzzuhriyah B. Haji Subir, Muammer Din Arif
Chapter 2: Conventional Technologies of Processing in Mechanical Engineering
Abstract:Tool wear, especially flank wear, is a major concern in the manufacturing industry. Increased tool wear is caused by chatter and leads to...
117