Paper Title:
Machinability Improvement by Workpiece Preheating during End Milling AISI H13 Hardened Steel
  Abstract

Surface finish and dimensional accuracy is one of the most important requirements in machining process. Inconel 718 has been widely used in the aerospace industries. High speed machining (HSM) is capable of producing parts that require little or no grinding/lapping operations within the required machining tolerances. In this study small diameter tools are used to achieve high rpm to facilitate the application of low values of feed and depths of cut to investigate better surface finish in high speed machining of Inconel 718. This paper describes mathematically the effect of cutting parameters on Surface roughness in high speed end milling of Inconel 718. The mathematical model for the surface roughness has been developed in terms of cutting speed, feed rate, and axial depth of cut using design of experiments and the response surface methodology (RSM). Central composite design was employed in developing the surface roughness models in relation to primary cutting parameters. Machining were performed using CNC Vertical Machining Center (VMC) with a HES510 high speed machining attachment in which using a 4mm solid carbide fluted flat end mill tool. Wyko NT1100 optical profiler was used to measure the definite machined surface for obtaining the surface roughness data. The predicted results are in good agreement with the experimental one and hence the model can be efficiently used to predict the surface roughness value with in the specified cutting conditions limit.

  Info
Periodical
Advanced Materials Research (Volumes 264-265)
Edited by
M.S.J. Hashmi, S. Mridha and S. Naher
Pages
888-893
DOI
10.4028/www.scientific.net/AMR.264-265.888
Citation
M. Suhaily, A.K.M. Nurul Amin, A. U. Patwari, "Machinability Improvement by Workpiece Preheating during End Milling AISI H13 Hardened Steel", Advanced Materials Research, Vols. 264-265, pp. 888-893, 2011
Online since
June 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Y.H. Wang, X.F. Yu, Ye Tai Fei
Abstract:Based on the differential confocal microscopy principle, a non-scanning 3D profile detecting system is proposed. A 2D light source array...
501
Authors: Y.S. Wang, Juan Juan Wang, J.B. Lei, Xi Chen Yang
Abstract:The profile and temperature distribution of laser molten pool are mainly factors which have directly effect on quality of laser processing...
141
Authors: Xiao Qin Li, Zhi Xiong Lu, Lan Ying Zhao, Zheng Hao Li, Bing Guo, Xue Feng Bai
Chapter 3: Advanced Test and Measurement
Abstract:This article did some non-contact measurement by laser triangulation principle on the A level hard road roughness, based on CCD imaging...
812
Authors: Xiao Feng Feng, Qian Zhang, You Jun Liao
Chapter 7: Detection and Diagnosis
Abstract:In order to meet the requirement of high precision and high efficiency in parts detection, the paper made the research on parts...
599
Authors: Wei Guo Bai, Chun Li Qiu, Jian Zhang
Chapter 3: Techniques for Measurement, Detection and Monitoring
Abstract:This paper introduces the use of self-made CCD camera system for acquiring the information of self-made controller strip on specific areas of...
543