Paper Title:
Hot Deformation Behavior and Fracture of As-Extruded 7075 Aluminum Alloy
  Abstract

Based on the isothermal compression experiment under constant strain rate, the deformation behavior and flow stress of as-extruded 7075 aluminum alloy at high temperature was studied. Then the fracture behavior and mechanism of 7075 aluminum alloy were investigated, the results showed that longitudinal cracking was easy to occur at a high temperature due to additional tensile stress and low melting point alloy in grain boundaries melting. Through analysis and comparing of C&L and Oyane fracture criteria, it was proved that C&L fracture criterion was more reasonable to predict fracture in 7075 aluminum alloy hot deforming, and the critical damage factor in a forming temperature range(300~450°C) for 7075 aluminum alloy was obtained.

  Info
Periodical
Advanced Materials Research (Volumes 291-294)
Chapter
Mechanical Behavior & Fracture
Edited by
Yungang Li, Pengcheng Wang, Liqun Ai, Xiaoming Sang and Jinglong Bu
Pages
1051-1056
DOI
10.4028/www.scientific.net/AMR.291-294.1051
Citation
Z. C. Sun, J. H. Wang, Y. Wang, H. Yang, "Hot Deformation Behavior and Fracture of As-Extruded 7075 Aluminum Alloy", Advanced Materials Research, Vols. 291-294, pp. 1051-1056, 2011
Online since
July 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Chang Liang Li, Hua Ding, Yong Qing Zhao, Lian Zhou
Abstract:Superplastic forming provides a good way for Ti alloys which are usually difficult to be deformed. Ti75 alloy with a nominal composition of...
2969
Authors: Zhi Guo Chen, Zi Qiao Zheng, Dong Feng Han
Abstract:The hot deformation behaviors and microstructure in Al-Cu-Li alloy containing small amount of Ag and Mg were investigated by transmission...
1925
Authors: Zhi Min Zhang, Qiang Wang, B.C. Li, X. Zhang
Abstract:Warm compression tests of AZ31 Mg alloy were carried out at five temperatures in 30°C intervals from 210°C to 330°C. The samples of...
1813
Authors: Cui Fang Duan, Wei Li, Ji Liang Zhang
Chapter 4: Material Engineering and its Application Technology
Abstract:This article studies aluminum alloy plate through 16 to 3mm thick with a hole under room temperature fracture test. The experimental results...
315
Authors: Xin Wu Ma, Guo Qun Zhao, Wen Juan Li
Chapter 5: Materials Processing and Chemical Technologies
Abstract:A new method for determination of friction coefficient in sheet metal forming of Mg alloy AZ31B is presented in this paper. The method is...
430