Paper Title:
Crystal Plasticity Finite Element Modelling of BCC Deformation Texture in Cold Rolling
  Abstract

Taylor-type and finite element polycrstal models have been embedded into the commercial finite element code ABAQUS to carry out the crystal plasticity finite element modelling of BCC deformation texture based on rate dependent crystal constitutive equations. Initial orientations measured by EBSD were directly used in crystal plasticity finite element model to simulate the development of rolling texture of IF steel under various reductions. The calculated results are in good agreement with the experimental values. The predicted and measured textures tend to sharper with an increase of reduction, and the texture obtained from the Taylor-type model is much stronger than that by finite element model. The rolling textures calculated with 48 {110}<110>, {112}<111> and {123}<111> slip systems are close to the EBSD results.

  Info
Periodical
Edited by
John Bell, Cheng Yan, Lin Ye and Liangchi Zhang
Pages
251-254
DOI
10.4028/www.scientific.net/AMR.32.251
Citation
H. J. Li, J. T. Han, Z. Y. Jiang, H. C. Pi, D. B. Wei, A. K. Tieu, "Crystal Plasticity Finite Element Modelling of BCC Deformation Texture in Cold Rolling", Advanced Materials Research, Vol. 32, pp. 251-254, 2008
Online since
February 2008
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Jin Sheng Qiu, Jie Meng
Abstract:By the universal testing machine and special fixture, the leaf spring suspension was tested for deformation, and based on nonlinear finite...
478
Authors: Jing Shun Fu, Jun Feng Wang, Jin Wang
Chapter 22: Computer-Aided Engineering in Manufacturing
Abstract:The finite element model of drive axle housing was built by using the solid element and the shell element respectively. Vertical bend...
5681
Authors: An Liang Song, Hong Dong Ran, Ming Zhou Su, Zhen Shan Wang, Yun Shi
Chapter 2: Structural Engineering
Abstract:Finite element analysis have been carried out in order to study the mechanical properties of the joints between elevated columns and truss...
949