Paper Title:
Study on the Mechanical Properties of Jute/Carbon Hybrid Composites
  Abstract

Carbon fibers were used to lay lengthways into three lays in jute fiber needled mat and the same fiber volume content of jute fiber needled mat were fabricated. Those two mats and the lengthways carbon fibers reinforced vinyl resin composites were made by VARTM. We made a comparison of the hybrid reinforced composites between the test value and the theoretical value which was predicted by establishing tensile and bending math-model and their mechanical properties were analyzed. The results show that there was a certain line between the theoretical value and the test value of the hybrid composites, so we can establish the mixing ratio between jute fiber and carbon fiber during the engineering application. Although the use of carbon fibers had greatly enhanced the tensile properties of hybrid composite, whose tensile strength and tensile modulus increased by 85.94% and 30.99% respectively than that without carbons, the bending model can’t be changed a lot.

  Info
Periodical
Chapter
Chapter 1: Textile Science and Technology
Edited by
Rui Wang and Huawu Liu
Pages
110-114
DOI
10.4028/www.scientific.net/AMR.331.110
Citation
J. M. Wang, L. Zhao, X. Qin, "Study on the Mechanical Properties of Jute/Carbon Hybrid Composites", Advanced Materials Research, Vol. 331, pp. 110-114, 2011
Online since
September 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Bing Xue, Ying Cheng Hu, Fang Chao Cheng
Abstract:Laminated Veneer Lumber (LVL) panels made from birch (Betula platyphylla Suk.) veneers were tested for physical and mechanical strength...
576
Authors: M. Mehrara, Mohammad Javad Nategh
Abstract:The bending of plates on rubber pad is a relatively new method used for roll bending of thin plates in recent years. In the present work the...
190
Authors: Cai Yun Yang, Xiu Ping Zan, Zhen Ying Hu, Jing Li
Chapter 1: Material Engineering and its Application
Abstract:Two different kinds of structural preforms were designed and manufactured, which were 3D layer-to-layer angle-interlock structure and 3D...
95
Authors: Dong Chen, Zhe Chen, Peng Zhang, Yi Jie Zhang, Haiheng Ma, Hao Wei Wang
Chapter 5: Metal Alloy Materials
Abstract:In-situ TiB2 particles reinforced AA7055 composites were fabricated through mixed-salts route and their bending properties were...
1005
Authors: A Ying Zhang, Dong Xing Zhang
Chapter 1: Composites
Abstract:The effects of voids on the bending strength and ILSS of CFRP laminates were discussed in this paper. The bending strength and ILSS of...
25