Paper Title:
Effect of New Type Gill pin Taker-in on Polyester Yarn Hairiness
  Abstract

Effect of carding machine using gill pin taker-in on polyester yarn hairiness was studied. The hairiness of the yarn processed by carding machine with gill pin taker-in and saw-tooth taker-in respectively, which using three-grade speed was tested by YG172 Yarn Hairiness Tester. The results show that (1) when using gill pin taker-in, it is most advantageous to the reduction of hairiness of 2 mm and above when the taker-in speed is 1290 r/min, while it is most advantageous to the reduction of hairiness of 3 mm and above when the taker-in speed is 820 r/min; (2) when using saw-tooth taker-in, it is most advantageous to the reduction of yarn hairiness when the taker-in speed is 1290 r/min; (3) the hairiness of the yarn processed by gill pin taker-in is more than that processed by saw-tooth taker-in as a whole.

  Info
Periodical
Advanced Materials Research (Volumes 332-334)
Chapter
Chapter 3: Fiber Manufacturing Technology
Edited by
Xiaoming Qian and Huawu Liu
Pages
545-548
DOI
10.4028/www.scientific.net/AMR.332-334.545
Citation
M. G. Zhang, X. Z. Yu, P. Z. Sun, "Effect of New Type Gill pin Taker-in on Polyester Yarn Hairiness", Advanced Materials Research, Vols. 332-334, pp. 545-548, 2011
Online since
September 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Zhen Hua Li, Yan Xiang Li
Abstract:In order to clarify the effect of antimony on graphite morphology and mechanical properties in heavy section ductile iron, experiments were...
2769
Authors: Gabriela Sima, Mihail Mangra, Oana Gîngu, Marius Catalin Criveanu, Bebe Adrian Olei
Abstract:The paper presents the experimental results regarding the influence of the reinforcing elements on the wear behavior of Al-matrix composites...
241
Authors: P.S. Pa
Chapter 2: Manufacturing and Design Science
Abstract:The current study discusses the surface finish of several common die materials, of which the screw-surface is finished by compound processes...
857
Authors: P.S. Pa
Chapter 2: Advanced Manufacturing Technologies
Abstract:This study using ultrasonic energy transmitted into the electrolyte to assist in discharging of electrolytic product out of the machining gap...
205
Authors: Er Bu Shen, Da Jing Fang, Ya Ping Wang, Jun Huang
Chapter 2: Building, Construction and Environmental Research
Abstract:Studied a variety of factors that affect the efficiency of electrochemical desalination. Using electrochemical methods and analytical...
663