Paper Title:
A Development of Lancing Engineering Method for Lamp-CAN Stamping Process by Using Forming Analysis
  Abstract

The products manufactured by the Sheet metal process are widely used in automobile and aircraft industries due to their high strength and superior surface characteristics. In this study, to improve the formability of the lamp-can, forming process was conducted using the Lancing engineering method. Lancing process is a press operation in which the work-piece is sheared and cut with one strike of the die to be a single-line cut or split, without removing any metal. Finite element method (FEM) was used to predict and investigate the improvement of formability of a lam-can with lancing process. As a result, it is believed that the Lancing process used in lamp-can forming would be helpful in the development of high-quality forming products because it can make material flow run well.

  Info
Periodical
Chapter
Chapter 3: Materials Forming/Machining/Joining
Edited by
Prasad Yarlagadda, Yun-Hae Kim, Zhijiu Ai and Xiaodong Zhang
Pages
443-447
DOI
10.4028/www.scientific.net/AMR.337.443
Citation
D. W. Jung, D. H. Kim, B. C. Kim, D. L. Ko, D. T. Nguyen, "A Development of Lancing Engineering Method for Lamp-CAN Stamping Process by Using Forming Analysis", Advanced Materials Research, Vol. 337, pp. 443-447, 2011
Online since
September 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: L.J. Wang, Zheng Dong Wang, Guo Dong Wang, Xiang Hua Liu
613
Authors: Yin Fang Jiang, Lei Fang, Zhi Fei Li, Zhen Zhou Tang
Abstract:As a new lightweight material and new technique,Tailor Rolled Blanks has a good prospect in energy-saving environmental protection and the...
488
Authors: Mohsen Loh-Mousavi, Amir Masoud Mirhosseini, Ghasem Amirian
Abstract:In recent years, tube hydroforming has been applied in automobile and airplane industries, to decrease weight. In general, the determination...
5
Authors: Jong Hoon Yoon, Ho Sung Lee, Yeng Moo Yi, Joon Tae Yoo
IV. Design, Testing and Modelling
Abstract:In the current study, the finite element simulation for superplastic blow forming of a toroidal Ti-6Al-4V fuel tank is discussed. 3 types of...
240
Authors: Yi Chern Hsieh, Minh Hai Doan, Chien Min Hung
Chapter 2: Advanced Design for Thermal and Mechanical Engineering
Abstract:PET prefom surface temperature distribution is a key factor for getting the better quality of construction a bottle by stretch blow molding...
269