Paper Title
Page
Authors: Abdoulmohammad Gholamzadeh Chofreh, Feybi Ariani Goni, Mahdieh Gholamzadeh Jofreh
Chapter 1: Advanced Design Technology
Abstract:Enterprise Resource Planning (ERP) system is an advanced manufacturing system that enables the integration of transactions-oriented data and...
152
Authors: Yi Luen Li, Ming Yuan Shen, Wei Jen Chen, Chin Lung Chiang, Ming Chuen Yip
Chapter 1: Advanced Design Technology
Abstract:In recent years, it has been observed that surface modification of carbon nanotubes(CNTs)influences on CNT’s distribution among epoxy resin...
156
Authors: Xiao Liu, Ge Ning Xu, Ping Yang
Chapter 1: Advanced Design Technology
Abstract:According to the distribution type of the uncertain parameters not acquired accurately in the probabilistic reliability, the interval model...
166
Authors: Noor Hidayah Abu, Baba M. Deros, Dzuraidah Abdul Wahab, Mohd Nizam Ab Rahman
Chapter 1: Advanced Design Technology
Abstract:Success in the pre-development process is important for every organization in order to compete with competitors. In order to survive,...
171
Authors: Zi Dong Yang, Li Fang Peng
Chapter 2: CAD/CAM/CAE
Abstract:According to the purpose and requirements of a virtual test, the complex mechanism of the combine harvester was abstracted and simplified to...
179
Authors: Wei Fan, Xin Liu
Chapter 2: CAD/CAM/CAE
Abstract:As the core components in the wind power generator set, the maintenance of gear box is very difficult, and its maintenance fee also is...
185
Authors: Yan Hai Chen, Xiao Guang Han, Ye Guang Yang, Yu Zhu Li
Chapter 2: CAD/CAM/CAE
Abstract:Aiming at the problems of low assembly precision and inefficient in the process of assembling thin-wall components of aircrafts , using the...
189
Authors: Lei Lei, Tian Min Guan, Jiang Bo Li
Chapter 2: CAD/CAM/CAE
Abstract:When the FA pin-cycloid drive is used in high precision control drive system, especially in the robot drive, there are strict requirements to...
193
Authors: Lin Fu, Chang Long Du, Kui Dong Gao
Chapter 2: CAD/CAM/CAE
Abstract:In order to do research on dynamic characteristics of auger miner’s working mechanism, three-dimensional entity model was built by software...
199
Authors: Yu Liu, Yi Min Li, Qing Kun Xia, Hao He, Guang Yao Wang
Chapter 2: CAD/CAM/CAE
Abstract:The 3D injection discrete element model of blade injection part is constructed. PFC3D is used to program for filling simulation and analysis....
205
Showing 31 to 40 of 157 Paper Titles