Paper Title:
Texture Analysis of Turned Surface Images Using Grey Level Co-Occurrence Technique
  Abstract

The main purpose of this work was to study the applicability of an image texture analysis method, namely, the grey level co-occurrence matrix (GLCM) method for the examination of the smoothness of the images of a turned surface. The effect of the variation of the pixel pair spacing (pps) on the construction of the GLCM was also considered and then, contrast and homogeneity were calculated from the GLCMs which served as texture descriptors for the quality of the machined surface. Finally, the variation of these texture descriptors with cutting time was analyzed and compared with the variation of tool wear and surface roughness with cutting time.

  Info
Periodical
Chapter
Chapter 1: Materials Engineering and Industry
Edited by
Barry Tan
Pages
38-43
DOI
10.4028/www.scientific.net/AMR.365.38
Citation
A. Datta, S. Dutta, S. K. Pal, R. Sen, S. Mukhopadhyay, "Texture Analysis of Turned Surface Images Using Grey Level Co-Occurrence Technique", Advanced Materials Research, Vol. 365, pp. 38-43, 2012
Online since
October 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: D.P. Li, Ying Xue Yao
Abstract:In the paper, the experimental study of grinding process of 2024Al/SiCp composites with the electroplated diamond wheel was conducted. The...
406
Authors: Y.F. Ge, Jiu Hua Xu, Hui Yang, S.B. Luo, Yu Can Fu
Abstract:Ultra-precision turning tests on SiCp/2024Al and SiCp/ZL101A composites were carried out to investigate the surface quality using single...
626
Authors: Yang Qiao, Xing Ai, Zhan Qiang Liu
Chapter 11: Materials Forming and Machining
Abstract:Powder metallurgy (PM) nickel-based superalloy is regarded as one of the most important aerospace industry materials, which has been widely...
1635
Authors: Peter Monka
Chapter 4: Advances in Tool-Chip Technology, Machining and Surface Roughness
Abstract:The paper deals with the experiments realized by means of cutting tool with linear cutting edge not parallel with the axis of the workpiece...
352
Authors: Li Zhou, Yu Zhong Li, Cheng Yong Wang
Chapter 14: Materials Machining
Abstract:The surface quality of graphite cannot be completely evaluated only by the roughness value Ra measured by profilometer. The surface damage...
2196