Paper Title:
Design on 3D Complex Groove of Turning Inserts with MATLAB
  Abstract

The paper presented a method of designing grooves of turning insert with 3D complex groove; and deduced equation calculating the width of the grooves using condition equation of the chip breaking, the parameters included in the equation was taken place by equivalent ones. And the grooves width is computed by MATLAB, and then the curve of the groove is fitted. The width can be used to create model of the turning inserts with 3D complex groove by Pro/Engineer, and the model can be imported in ANSYS soft to simulate turning process and analysis groove performance. All this work provides a base for the groove design and optimization

  Info
Periodical
Advanced Materials Research (Volumes 69-70)
Edited by
Julong Yuan, Shiming Ji, Donghui Wen and Ming Chen
Pages
636-640
DOI
10.4028/www.scientific.net/AMR.69-70.636
Citation
X.M. Feng, G. Y. Tan, G. H. Li, Y. H. Zhang, "Design on 3D Complex Groove of Turning Inserts with MATLAB", Advanced Materials Research, Vols. 69-70, pp. 636-640, 2009
Online since
May 2009
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Y. He, Zheng Qiang Yao
Abstract:End mills are very widely used in machining metal. In this paper, based on analysis of three different end milling indexable inserts with 3-D...
775
Authors: E.L. Liu, Rong Di Han, Zhen Jia Li, Hui Ping Zhang, Guo Liang Wei
Abstract:As machining technology develops toward the unmanned and automated system, the need for chip-breaking control is considered increasingly...
752
Authors: Hui Ping Zhang, Zhen Jia Li, Er Liang Liu, Guo Liang Wei
Abstract:This paper deals with chip breaking behaviour of 3-D complex groove inserts in machining carbon constructional steel-45 steel at high...
206
Authors: Zhen Xiang Tu
Chapter 1: Architectonics and Materials Study
Abstract:The mechanical and physical properties of Austenitic stainless steel are analyzed in detail in this paper, and the main problems of the...
88
Authors: Qing Yan Ma, Biao Wang, Da Guo Yu
Chapter 20: Detection and Control Technology
Abstract:In the drilling process for deep hole, the continuous chips often jam up due to the difficulty of chip removal, and the chips cause problems...
2688