Paper Title
Page
Authors: Zi Guo Mu, Min Lei, Yi Long Liang, De Yin Peng, Deng Wei Tang
Chapter 1: Novel and Advanced Materials, Materials Science and Technologies
Abstract:The manufacture materials of air conditioner compressor vane require the properties of proficient red hardness and wear behavior. So the...
324
Authors: Ya Bo Fu, Xue Lin Chen
Chapter 1: Novel and Advanced Materials, Materials Science and Technologies
Abstract:The cutting tool material of 9SiCr4 is widely applied in the manufacturing. The paper studied the microstructure and surface oxides on 9SiCr4...
328
Authors: Sheng Zhu, Yu Xiang Liu, Xiao Ming Wang, Guo Feng Han
Chapter 1: Novel and Advanced Materials, Materials Science and Technologies
Abstract:Effect of Supersonic Particles Deposition processing parameters on porosity and bonding strength of Al-Si coating on the surface of ZM5...
332
Authors: Dan He, Lu Xia, You Shou Zhang, Jin Huang
Chapter 1: Novel and Advanced Materials, Materials Science and Technologies
Abstract:Regarding dry strength and storage strength of high neutralization degree compound phosphate no-bake sand as index, optimization was analyzed...
337
Authors: Chen Wang, Teng Fei Chen, Jie Tao
Chapter 1: Novel and Advanced Materials, Materials Science and Technologies
Abstract:Al coatings were prepared on 316L stainless steel substrate by arc-added glow plasma depositing technique and then plasma oxidized. The...
342
Authors: Zhi Qin Zhong, Cheng Tao Yang, Guo Jun Zhang, Shu Ya Wang, Li Ping Dai
Chapter 1: Novel and Advanced Materials, Materials Science and Technologies
Abstract:Dry etching of Pt/Ti film was carried out using Cl2/Ar plasmas in an inductively coupled plasma (ICP) reactor. The influence of...
346
Authors: Yi Miao Nie, Shao Bo Wei, Xiao Long Lu, Shu Xian Liu
Chapter 1: Novel and Advanced Materials, Materials Science and Technologies
Abstract:Based on the crystal structure research of sericite and muscovite in mineralogy, research of sericite was done by the analysis of XRD,IR ,SEM...
350
Authors: Guang Zeng, Sen Lin Zhao, Lai Wei, Run Ze Huang, Modiri Badirwang
Chapter 2: Advanced Manufacturing and Control Technologies
Abstract:For study of technical difficulties that make Botswana first CFB (Circulating Fluidized Bed) boiler can’t reach full load at beginning of...
357
Authors: Yao Kun Ye, Nan Yan, Feng Ding, Jian Feng Man
Chapter 2: Advanced Manufacturing and Control Technologies
Abstract:In order to study the work principle and separation features of an explosive separation device used in aerospace craft, this research...
363
Authors: Yong Kui Sun, Zhi Bin Yu
Chapter 2: Advanced Manufacturing and Control Technologies
Abstract:Analog circuits fault diagnosis using multifractal analysis is presented in this paper. The faulty response of circuit under test is analyzed...
367
Showing 71 to 80 of 155 Paper Titles