Paper Title:
A Study on the Micro Property Testing of Micro Embossing Patterned Metallic Thin Foil
  Abstract

In this paper, Experimental results on the measurement of mechanical properties of fine patterns in the MEMS structure are described. The mechanical properties of embossing patterns on metallic thin foil is measured using the nano indentation system, that is developed by Korea Institute of Industrial Technology(KITECH). These micro embossing patterns are fabricated using CIP(Cold Isostatic Press) process on micro metallic thin foils(Al-1100) that are made by rolling process. These embossing patterned metallic thin foils(Al-1100) are used in the reflecting plate of BLU(Back Light Unit) and electrical/mechanical MEMS components. If these mechanical properties of fine patterns are utilized in a design procedure, the optimal design can be achieved in aspects of reliability as well as economy.

  Info
Periodical
Key Engineering Materials (Volumes 345-346)
Edited by
S.W. Nam, Y.W. Chang, S.B. Lee and N.J. Kim
Pages
335-338
DOI
10.4028/www.scientific.net/KEM.345-346.335
Citation
H. J. Lee, N. K. Lee, H. W. Lee, "A Study on the Micro Property Testing of Micro Embossing Patterned Metallic Thin Foil", Key Engineering Materials, Vols. 345-346, pp. 335-338, 2007
Online since
August 2007
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Hong Gue Shin, Heon Young Kim, Byeong Hee Kim
Abstract:Nano hot or thermal embossing has many advantages of comparatively few process steps, simple operation, relatively low tooling cost and high...
925
Authors: Yong Liang, Chong Liu, Huan Li Sun, Jing Min Li, Jun Shan Liu, Xian Ni Gao
Abstract:During hot embossing process of polymer MEMS devices, the parameters such as temperature, pressure and time are important for the duplication...
450
Authors: Wei Lin, Wen Jie Chen, Choon Meng Kiew, Chuen Leong Ng, Hong Luo, Chek Sing Teo, Gui Ling Yang
Abstract:This paper addresses the limitations of current hot embossing machines for mass production applications. It describes the features of a hot...
483
Authors: Yong He, Ting Zhang, Jian Zhong Fu, Zi Chen Chen
Abstract:To improve the quality of the light guide plate (LGP) made by injection molding, a fabrication method based on hot embossing was proposed....
448
Authors: A.B. Abdullah, S.M. Sapuan, Z. Samad, H.M.T. Khaleed, N.A. Aziz
Chapter 14: Modeling, Analysis, and Simulation of Manufacturing Processes
Abstract:Accuracy of the net-shape manufacturing such as forging becomes critical as the process depends on many factors. Defect will harm the...
2337