Paper Title:
Application of Wear Resistant Coating Technology on Coating Blade
  Abstract

Coating blade wears seriously in paper coating process. Wear mechanism was analyzed in this article. A new technology of surface coating process was introduced to increase the hardness of the edge of coating blade and thus to prolong its service life. Surface coating preparing process on blade was studied and metal-ceramic compound coating prepared successfully on the edge of coating blade with AT13 (Al2O3+13%TiO2) wear resistant material by plasma spraying process. NiCrAl alloy powder was used as under coat material. Microstructure of the coating is dense. The coating bonds well with the matrix and have high hardness. Results of grain-abrasion testing show that wear-resisting property of the metal/ceramic compound coating is about 7-8 times as that of steel blade.

  Info
Periodical
Key Engineering Materials (Volumes 353-358)
Edited by
Yu Zhou, Shan-Tung Tu and Xishan Xie
Pages
1761-1764
DOI
10.4028/www.scientific.net/KEM.353-358.1761
Citation
C. M. Wang, H. F. Sun, Q. Song, Q. Q. Yan, "Application of Wear Resistant Coating Technology on Coating Blade", Key Engineering Materials, Vols. 353-358, pp. 1761-1764, 2007
Online since
September 2007
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Ying Ning Hu, Cheng Yong Wang, H.N. Ding, Z.W. Wang
Abstract:The wear mechanism of several kinds of diamond circular saw blades was studied in the different sawing parameters during dry cutting of...
315
Authors: Keun Bong Yoo, Han Sang Lee
Abstract:Many investigations about superalloys and coatings have been done in the laboratory, but evaluating the degradation condition of hot section...
2523
Authors: Keun Bong Yoo, Han Sang Lee, Doo Soo Kim
Abstract:Many investigations about superalloys and coatings have been done in the laboratory, but evaluating the degradation condition of hot section...
113
Authors: Xi Cong Ye, Wei Guang Zhao, Wen Jun Liu, Shuang Qing Tang, Zi Fan Fang
Chapter 2: Materials Science and Engineering
Abstract:In this paper, the bottom pouring vacuum suction casting is used, and the TiAl-based alloy blade with a certain flexivity, the brim thickness...
400
Authors: F. Ismail, Shahjahan Mridha
Chapter 4: Materials
Abstract:The superalloy of Inconel 718 variety is widely used to produce compressor blade in gas turbine engine. The blade tip invariably wears in...
459