Paper Title:
Texture Evolution of Rolled AA3003 Alloy Sheets after Annealing
  Abstract

To fabricate the aluminum alloys with good drawability, the textures evolution of the 3003 aluminum alloy sheets after rolling and subsequent annealing was studied. The measurement of the deformation textures was carried out for the sheets in which were cold rolled with high reduction ratio by using the symmetric roll. In addition, the change of the recrystallization texture was investigated after heat-treatments of the rolled sheets with various heat treatment conditions. Rolling without lubrication and subsequent annealing led to the formation of favorable rot-CND {001}<110> and γ-fiber ND//<111> textures in 3003 aluminum alloy sheets. From the results, the γ-fiber ND//<111> component well evolved during rolling at high reduction ratio (reduction over 90%, l/d parameter over 6.0). Among shear deformation textures, the γ-fiber ND//<111> was not rotated during recrystallization (350°C) in special condition.

  Info
Periodical
Key Engineering Materials (Volumes 353-358)
Edited by
Yu Zhou, Shan-Tung Tu and Xishan Xie
Pages
579-582
DOI
10.4028/www.scientific.net/KEM.353-358.579
Citation
K. J. Kim, J. S. Kim, C. W. Kim, I. S. Sohn, J. Y. Lee, J. B. Kim, "Texture Evolution of Rolled AA3003 Alloy Sheets after Annealing", Key Engineering Materials, Vols. 353-358, pp. 579-582, 2007
Online since
September 2007
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: No Jin Park, S.J. Jin, C.W. Jea, Seong Taek Lim, Yong Yun Lee, Dong-Seok Chung
Abstract:After extrusion, cold rolling and T-6 treatment, microstructure, texture development, and deep drawability of...
213
Authors: Olaf Engler, Yuguo An
Abstract:The control of the plastic anisotropy during forming of a metallic sheet requires detailed knowledge on its microstructure and, especially,...
277
Authors: Ch. Hartig, A. Styczynski, F. Kaiser, Dietmar Letzig
Abstract:The plastic anisotropy was measured for a commercial AZ31 magnesium sheet and compared with results from a model calculation using a self...
1615
Authors: J.A. del Valle, Oscar A. Ruano
Abstract:The effect of annealing treatments on the evolution of the strain rate sensitivity with strain of AZ61 magnesium alloy processed by severe...
1524
Authors: De Bin Chen, Hui E Hu, Xiao Dong Kong
Chapter 1: Materials Engineering
Abstract:Plastic anisotropy of the as-rolled 7050 aluminum alloy plate with T7451 temper was investigated by tensile tests, OM, SEM and TEM. The...
130