Paper Title:
Preparation of Microcrystalline CBN Abrasive
  Abstract

In this paper microcrystalline CBN abrasives are prepared with CBN powders and vitrified bond additives by pressureless sintering method. Mechanical properties of the products are measured by using single particle compressive strength tester and three-point bending strength tester. The effects of vitrified bond additives, the CBN powders particle size and the sintering temperature on the performance of microcrystalline CBN abrasives are investigated. The microstructure characteristics of microcrystalline CBN abrasives are examined. The results showed that the performance and microstructure of microcrystalline CBN abrasives are significantly influenced by particle size of CBN powder and the addition amount of vitrified bond.

  Info
Periodical
Key Engineering Materials (Volumes 368-372)
Edited by
Wei Pan and Jianghong Gong
Pages
933-935
DOI
10.4028/www.scientific.net/KEM.368-372.933
Citation
A. J. Zhang, Z. H. Li, Z. C. Li, Y. M. Zhu, "Preparation of Microcrystalline CBN Abrasive", Key Engineering Materials, Vols. 368-372, pp. 933-935, 2008
Online since
February 2008
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Zhi Hong Li, Y.M. Zhu, Xia Wan Wu, Q.M. Yuan, Zheng Fang Yang
33
Authors: Yi Qing Yu, Yuan Li, Xipeng Xu
Abstract:An investigation is reported of the characteristics of specific energy in grinding of granite using diamond abrasives. The effects of many...
625
Authors: Ye Fa Tan, Bin Cai, Yi Qiang Tu, Ting Xu, Hua Tan, Chun Hua Zhou
Abstract:In order to improve the grinding performance and service life of electroplating composite coatings with high percent of hard abrasives, the...
1457
Authors: Zheng Xin Li, Rui Zhang, Xue Feng Yang, Xiang Rong Deng
Abstract:This paper first analyzes the characteristics of holding strength of ceramic adhesive to diamond grains within vitrified abrasives grinding...
657
Authors: Zhi Gang Dong, C.W. Kang, L. Xu
Abstract:The paper reports an experimental study on the effect of honing parameters on the honing surface roughness, material removal rate and surface...
438