Paper Title:
Investigation of Flow Instability in High Temperature Deformation of INCONEL Alloy 783 Using Processing Map Approach
  Abstract

The high temperature deformation behavior and flow instabilities of Ni-Fe-Co base superalloy, INCONEL alloy 783 during hot working process were investigated with process maps consisting of a power dissipation of dynamic materials model (DMM) and various flow instability criteria. In order to establish the processing map of INCONEL alloy 783, hot compression tests were carried out under different temperature and strain rate conditions, with true strain up to 0.7. On the basis of the comparison between processing maps and microstructural analysis, the reliability of various flow instability criteria was estimated. Finally the useful instability criterion for predicting the forming defects was suggested through the compression test results and experimental observations of actual ring rolling process of INCONEL alloy 783.

  Info
Periodical
Key Engineering Materials (Volumes 385-387)
Edited by
H.S. Lee, I.S. Yoon and M.H. Aliabadi
Pages
501-504
DOI
10.4028/www.scientific.net/KEM.385-387.501
Citation
J. T. Yeom, E. J. Jung, J. H. Kim, J. K. Hong, N. K. Park, S. S. Choi, C. S. Lee, "Investigation of Flow Instability in High Temperature Deformation of INCONEL Alloy 783 Using Processing Map Approach", Key Engineering Materials, Vols. 385-387, pp. 501-504, 2008
Online since
July 2008
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Chang Liang Li, Hua Ding, Yong Qing Zhao, Lian Zhou
Abstract:Superplastic forming provides a good way for Ti alloys which are usually difficult to be deformed. Ti75 alloy with a nominal composition of...
2969
Authors: Zhi Guo Chen, Zi Qiao Zheng, Dong Feng Han
Abstract:The hot deformation behaviors and microstructure in Al-Cu-Li alloy containing small amount of Ag and Mg were investigated by transmission...
1925
Authors: Zhi Min Zhang, Qiang Wang, B.C. Li, X. Zhang
Abstract:Warm compression tests of AZ31 Mg alloy were carried out at five temperatures in 30°C intervals from 210°C to 330°C. The samples of...
1813
Authors: Xin Wu Ma, Guo Qun Zhao, Wen Juan Li
Chapter 5: Materials Processing and Chemical Technologies
Abstract:A new method for determination of friction coefficient in sheet metal forming of Mg alloy AZ31B is presented in this paper. The method is...
430
Authors: B. Aashranth, Santosh Kumar, Dipti Samantaray, S.K. Albert, Utpal Borah, A.K. Bhaduri
Chapter 7: Materials Characterisation
Abstract:In this paper, microstructural evolution of Indian Fast Reactor Advanced Clad (IFAC-1) steel during thermo-mechanical processing has been...
350