Research on Machining Methods for Non-Circular Isometric Profile |
|
| Journal | Key Engineering Materials (Volumes 407 - 408) |
|---|---|
| Volume | Progress of Machining Technology |
| Edited by | Fan Rui, Qiao Lihong, Chen Huawei, Ochi Akio, Usuki Hiroshi and Sekiya Katsuhiko |
| Pages | 68-72 |
| DOI | 10.4028/www.scientific.net/KEM.407-408.68 |
| Citation | Hong Yan Wang et al., 2009, Key Engineering Materials, 407-408, 68 |
| Online since | February, 2009 |
| Authors | Hong Yan Wang, Xue Feng Yang, Pei Quan Guo |
| Keywords | Isometric Profile, Machining Approach for Turning Non-Circular Isometric Profile, Non-Circular Isometric Profile |
| Abstract | Two machining methods for non-circular isometric profile are introduced. The profile modeling technology and the numerical control technology are analyzed. The dynamic property of in a series profile modeling technology system is revealed, and the design principle for in a series profile modeling technology system is put forward, the value range of damping ratio is instanced at near 0.7. The turning machining system adopting linear servo motor as drive element is brought forward. |
| Full Paper | 
Get the full paper by clicking here
|
First page example
