Paper Title:
Prediction of Forces in Micro-Cutting and the Study Based on Simulation
  Abstract

In micro-cutting process, a remarkable characteristic of micro-Cutting is that cutting parameters level closing to the crystal grain msize of material. Though, the prediction formula of micro-cutting forces should reference to strain gradient plasticity theory in formula construction , while cutting edge radius had been regard as a important parameters in the process of micro-cutting. With advantedge FEM software for simulation of micro-cutting , the results show that, there was no significant effect of temperature on cutting force; strain gradient reaction will be decreased by feed rate’s reducing in process, cutting depth effected cutting force in linear mode, the max. workpiece temperature area is no longer the second deformation area but the primary deformation zone, while the max. temperature area of the tool would transfer to the tool tip from theoretical location of traditional cutting.

  Info
Periodical
Key Engineering Materials (Volumes 467-469)
Edited by
Dehuai Zeng
Pages
197-201
DOI
10.4028/www.scientific.net/KEM.467-469.197
Citation
H. Xiao, W. G. Wu, W.T. Mei, "Prediction of Forces in Micro-Cutting and the Study Based on Simulation", Key Engineering Materials, Vols. 467-469, pp. 197-201, 2011
Online since
February 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Wen Jun Deng, C. Li, Wei Xia, X.Z. Wei
Abstract:A coupled thermo-mechanical model of plane-strain orthogonal metal cutting including burr formation is presented using the commercial finite...
71
Authors: José Vitor C. Souza, Maria do Carmo de Andrade Nono, Rodrigo de Matos Oliveira, M.V. Ribeiro, Olivério Moreira Macedo Silva
Abstract:During gray cast iron cutting, the great rate of mechanical energy from cutting forces is converted into heat. Considerable heat is...
598
Authors: B.J. Xiao, Cheng Yong Wang, Ying Ning Hu, Yue Xian Song
Abstract:A two-dimensional orthogonal thermal-mechanical finite element model by Deform2D finite element analysis software is established in the...
590
Authors: Yue Feng Yuan, Wen Ying Zhang, Xing Chang
Chapter 6: New Materials and Advanced Materials
Abstract:Cutting force experiments in turning aluminum-silicon alloy ZL104 are carried out with cement carbide tool YG8. The influence of cutting...
971
Authors: Ji Cai Kuai
Chapter 3: Chemical and Biomedical Engineering
Abstract:The dynamic minimum thickness of cut for the ultra-precision machining surface quality is important influence. Between tool and the workpiece...
1246