Paper Title:
Experimental and Numerical Investigation of the Effect of Anisotropy on Springback in U-Bending Process
  Abstract

In this research, the effect of anisotropy on springback in CK67 steel sheet in U-bending process was studied by finite element simulation and experimental approach. The finite element software, ABAQUS/EXPLICIT 6.7, was used for simulation. In order to verify the simulation results some experiments were performed. The obtained results indicated that increasing the bending angle to the rolling direction resulted in an increase in springback. The results of the experiments were compared with simulation results. There was significant agreement between simulation and experiment.

  Info
Periodical
Main Theme
Edited by
J.R. Duflou, R. Clarke, M. Merklein, F. Micari, B. Shirvani and K. Kellens
Pages
645-652
DOI
10.4028/www.scientific.net/KEM.473.645
Citation
V. Daiezadeh, M. Elyasi, B. Rahmani, M. Bakhshi-Jooybari, "Experimental and Numerical Investigation of the Effect of Anisotropy on Springback in U-Bending Process", Key Engineering Materials, Vol. 473, pp. 645-652, 2011
Online since
March 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Oana Cazacu, Frédéric Barlat
537
Authors: Olaf Engler, Yuguo An
Abstract:The control of the plastic anisotropy during forming of a metallic sheet requires detailed knowledge on its microstructure and, especially,...
277
Authors: Ch. Hartig, A. Styczynski, F. Kaiser, Dietmar Letzig
Abstract:The plastic anisotropy was measured for a commercial AZ31 magnesium sheet and compared with results from a model calculation using a self...
1615
Authors: Marion Merklein, Jürgen Lecher, Vera Gödel, Stefania Bruschi, Andrea Ghiotti, Alberto Turetta
Abstract:Within the scope of this paper, the formability of the press hardenable steel 22MnB5 will be investigated with regard to its anisotropic...
79
Authors: Lei Chen
Chapter 10: Vibration, Dynamics and Acoustic Control
Abstract:Earing is often undesirable in the production of deep drawn containers because it results in a nonuniform cup height. A finite element model...
638