Paper Title:
Experimental Study of the Relationship between Tool Rod Parameters and Vibration Parameterson Ultrasonic Grinding (Wheel Vibration)
  Abstract

This paper proposes to use a method of ultrasonic milling on the composite materials processing, we mainly studies the effect of the length of the tool rod, tool rod diameter on the acoustic resonant frequency, amplitude, to ensure processing quality and improving the tool's vibration effect.

  Info
Periodical
Edited by
Feng Zhu, Xipeng Xu and Renke Kang
Pages
429-432
DOI
10.4028/www.scientific.net/KEM.487.429
Citation
Z. D. Li, B. Zhao, "Experimental Study of the Relationship between Tool Rod Parameters and Vibration Parameterson Ultrasonic Grinding (Wheel Vibration)", Key Engineering Materials, Vol. 487, pp. 429-432, 2011
Online since
July 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Yuan Liang Zhang, Zhi Min Zhou, Zhi Hui Xia
Abstract:Ultrasonic vibration is applied to diamond turning of special stainless steel to decrease diamond tool wear and improve the surface quality...
57
Authors: Shu You Zheng, Xipeng Xu
Abstract:Ultrasonic machining has been proven to be a promising machining method on hard and brittle materials. However, due to the absence of high...
150
Authors: Dong Lu, Hong Fu Huang, Yong Bo Wu, Ming Ming Yang
III. Micro/Nano-Fabrication
Abstract:Ultrasonic-vibration-assisted micro-cutting of Ti-6Al-4V was simulated by finite element analysis software ADVANTEDGE. During the...
345
Authors: Liang Wang, Guang Jun Chen, Ting Zhang, Ding Wen Wang, Ying Wang
Chapter 3: Recent Developments in High Speed Machine Tools and Cutting Tools
Abstract:Abstract: Corner radius as a non-main cutting parameters, study of corner radius about cutting vibration is relatively small.Turning...
228
Authors: Shou Xiang Lu, Hang Gao, Chao Sun, Yong Jie Bao, Zi Cheng Bao
Chapter 6: Electrical Discharge Machining, Ultrasonic and Beam Machining
Abstract:Aiming at the difficulty of 65% volume fraction SiCp/Al composites micro-hole machining and the problem of exit defects, the ultrasonic...
359