Paper Title:
Study on Depth and its Uniformity of 65Mn Steel Grind-Hardened Layer
  Abstract

On the basis of orthogonal experiment method, the grind-hardening of 65Mn steel had been carried out on a conventional surface grinder with alumina grinding wheel, the influence of depth of cut ap, table speed vw, grinding mode gm, and interaction between depth of cut and table speed av on depth and its uniformity of grind-hardened layer of 65Mn steel were investigated. The results show that, the ap is the significant factor influences the average depth of grind-hardened layer and the significance ratio of experiment factors from most to least as followed: ap > vw > gm > av; the gm and the vw are the significant factors influence the depth uniformity of grind-hardened layer and the significance ratio of experiment factors from most to least as followed: gm > vw > ap > av. The fairly uniformity of grind-hardened layer with good economy can be obtained when using grinding conditions that the ap = 0.6mm, the vw = 0.4m/min, and the gm =up grinding + down grinding in practical applications.

  Info
Periodical
Edited by
Feng Zhu, Xipeng Xu and Renke Kang
Pages
94-98
DOI
10.4028/www.scientific.net/KEM.487.94
Citation
J. Z. Zhuang, L. F. Liu, Y.Z. Zhang, "Study on Depth and its Uniformity of 65Mn Steel Grind-Hardened Layer", Key Engineering Materials, Vol. 487, pp. 94-98, 2011
Online since
July 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Ju Dong Liu, Gui Cheng Wang, Zhi Wang, Shu Tian Fan
Abstract:Grind-hardening was done on 65Mn steel with a conventional surface grinder and a corundum-grinding wheel. Research was conducted to probe...
787
Authors: Bo Zhao, Ming Li Zhao, Guo Fu Gao
Abstract:The influence of ultrasonic vibration on the surface roughness and micro-topography of ceramics plate is discussed in this paper. Grinding...
243
Authors: Wei Zhang, Min Li Zheng, Ming Ming Cheng, Quan Wan
Abstract:By using experiment cutter edge topography obtained by super depth three-dimension microscope, fits the cutter edge curve and calculate...
86
Authors: Wei Jun Tian, Yu Li, Zhen Chao Yang, Chang Feng Yao, Jun Xue Ren
Chapter 1: Advances in Manufacturing Engineering Techniques and Materials Science
Abstract:The paper is concerned with the effect of cutting parameters on surface microhardness in the high speed milling of titanium alloy TC17 with...
127
Authors: K.P. Zhang, Cheng Yong Wang, Ying Ning Hu, Yue Xian Song
I. Material Subtractive Processes: Cutting and Non-Traditional Processes
Abstract:7CrSiMnMoV (HRC65) hardened steel mold was cutted to investigate the effects of cutting parameters (cutting speed, feed speed, radial cutting...
32