Paper Title:
Comparison between 3D FEM and Standard ISO Tooth Root Stresses
  Abstract

The paper deals with the discussion how nominal spur tooth root stress of thin-rimmed gear determined in accordance with the standard ISO 6336-3:2006, method B, agrees with the results of the 3D FEM stress analysis. The procedure proposed by standard ISO for the tooth root stress calculation doesn’t identify the stress behaviour related to mutual affects of characteristic thin-rimmed gear geometrical parameters. Therefore, the 3D FEM analysis of tooth root stress has been performed for gear structures with middle and offset web with various rim and web thickness. The rim thickness has covered and slightly overcome the backup ratio defined by ISO procedure, while the web thickness has covered the range of practical interest.

  Info
Periodical
Key Engineering Materials (Volumes 488-489)
Edited by
Z. Tonković and M.H. Aliabadi
Pages
85-88
DOI
10.4028/www.scientific.net/KEM.488-489.85
Citation
G. Marunić, G. Gregov, V. Glažar, "Comparison between 3D FEM and Standard ISO Tooth Root Stresses", Key Engineering Materials, Vols. 488-489, pp. 85-88, 2012
Online since
September 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: R. Devaraj
Chapter 14: Design, Modeling and Simulation
Abstract:The main factors that cause the failure of gears are the bending stress and contact stress of the gear tooth. Out of these, failure of gears...
1070