This paper presents further results in addressing this issue and builds upon the results obtained within the project GACR No. 101/07/0751 (research was supported by Czech Grant Agency), and the findings and information obtained from grant project GACR No. 101/05/2562. The problems are oriented to the production and sharpening of rotary tools, especially because all the know-how is owned by foreign companies. The main chapter is devoted to "Solution of the dependance of undercutting of the helical grooves on the grinding wheel diameter, its thickness and depth of the cut" at zero thickness of the grinding wheel. This method is an original analytical method for calculating the undercutting and is a part of the theoretical studies of the grinding helix slot. Then follows a passage, which defines the actual width of the spiral groove profiles at various grinding wheels. The present article summarizes only part of a broad range of problems in the area.