Test Analysis of Milling Force of Titanium Alloy Base on MATLAB |
|
| Journal | Key Engineering Materials (Volume 499) |
|---|---|
| Volume | Anti-Fatigue Design and Manufacturing Technologies I |
| Edited by | Dunwen Zuo, Chuanzhen Huang, Ming Chen, Jun Li and Guo Hun |
| Pages | 324-329 |
| DOI | 10.4028/www.scientific.net/KEM.499.324 |
| Citation | L. Shi et al., 2012, Key Engineering Materials, 499, 324 |
| Online since | January, 2012 |
| Authors | L. Shi, Z.H. Jiang |
| Keywords | Power Spectrum, Range Analysis, Titanium Alloy, Wavelet Analysis |
| Abstract | Orthogonal experiments of milling titanium alloy TA12 were done on the lifting workbench milling machine. The milling force signals were acquired through PIC-1712 Data Acquired Board. The main frequencies and energy distribution were got through analysis in SPTOOL of MATLAB. The signals were decomposed and reconstructed based on the main frequency of the milling force with wavelet toolbox. The influence of the milling velocity, axial depth of cut and radial depth of cut on the component milling force was got through range analysis. Through analyzing known that three factors had different influence on the component milling force. |
| Full Paper | 
Get the full paper by clicking here
|
First page example
