Paper Title:
Texture Development in Nd-Fe-V Alloys by Hot Deformation in View of Permanent Magnet Properties
  Abstract

In this study, a hot forging process is applied to Nd-Fe-V as cast alloys in order to develop both the microstructure and the crystallographic texture appropriate for permanent magnet properties. A neutron diffraction texture analysis is used to account for the extrinsic magnetic anisotropy: the stabilisation of the Nd(Fe,V)12 hard magnetic phase has been achieved during forging but its extrinsic anisotropy level remains low. Attempts to understand this phenomenon are made through a discussion on the Nd-Fe-V alloy rheological and mechanical behaviour and a comparison with Nd-Fe-B permanent magnets.

  Info
Periodical
Materials Science Forum (Volumes 495-497)
Edited by
Paul Van Houtte and Leo Kestens
Pages
1389-1394
DOI
10.4028/www.scientific.net/MSF.495-497.1389
Citation
I. Popa, S. Rivoirard, D. Chateigner, T. Hansen, D. Fruchart, "Texture Development in Nd-Fe-V Alloys by Hot Deformation in View of Permanent Magnet Properties ", Materials Science Forum, Vols. 495-497, pp. 1389-1394, 2005
Online since
September 2005
Export
Price
$35.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Yuriy Perlovich, Margarita Isaenkova, M. Grekhov, Olga Krymskaya, Vladimir Fesenko, S. Zavodchikov, V. Kotrekhov
Abstract:Distinctive structure features of rods produced by hot and cold radial forging of a Zr- 2.5%Nb alloy were revealed. Most experimental data...
338
Authors: J.W. Bae, S.M. Lee, Chung Gil Kang
Abstract:This study demonstrates the indirect rheoforging of wrought aluminum alloys fabricated by electromagnetic stirring (EMS). EMS was carried...
277
Authors: Renat M. Imayev, Ayrat A. Nazarov, Radik R. Mulyukov
Abstract:On the basis of generalization of research results obtained at the Institute for Metals Superplasticity Problems, principles of fabrication...
1702
Authors: Tao Wang, Hong Zhen Guo, Jian Hua Zhang, Ze Kun Yao
Abstract:The microstructures and room temperature and 600°C tensile properties of Ti-5.8Al-4.0Sn-4.0Zr-0.7Nb -0.4Si-1.5Ta alloy after isothermal...
153
Authors: Chang Jiang Zhang, Fan Tao Kong, Shu Long Xiao, Li Juan Xu, Yuong Chen, Ning Jia Deng, We Ge, Guo Jun Xu
Abstract:In this work, 2.5vol. % (TiB+TiC)/Ti composite was prepared by in situ casting route then 1-D forging. The microstructure and tensile...
926