Paper Title:
Texture Evolution during Cold Rolling of Low and High Carbon Steel. Measurement and Simulation
  Abstract

This paper presents simulations of the texture development during cold rolling of fully pearlitic steel. In order to investigate the importance of including microstructural aspects into texture simulations the calculations were carried out with the FC Taylor Pearlite model which takes the lamellar microstructure into account and with the FC Taylor and LAMEL model which are dedicated for one phase materials. The results are compared with those for ULC steel. For both materials the LAMEL model results are in good agreement with experimental data, while for the pearlitic steel, the FC Taylor Pearlite model improves the predictions only slightly with respect to the FC Taylor model.

  Info
Periodical
Materials Science Forum (Volumes 495-497)
Edited by
Paul Van Houtte and Leo Kestens
Pages
369-374
DOI
10.4028/www.scientific.net/MSF.495-497.369
Citation
A. Walentek, X. Hu, M. Seefeldt, P. van Houtte, "Texture Evolution during Cold Rolling of Low and High Carbon Steel. Measurement and Simulation ", Materials Science Forum, Vols. 495-497, pp. 369-374, 2005
Online since
September 2005
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Xiahua Hu, Monique Gaspérini, Paul van Houtte
Abstract:In-situ SEM shearing tests were performed on samples from the heavily cold rolled (Extrahard) aluminium alloys, where the parallelepiped test...
363
Authors: Paul van Houtte, Albert Van Bael, Marc Seefeldt, Laurent Delannay
Abstract:The paper focuses on the multi-level character of existing or currently developed models for polycrystal deformation. A general multilevel...
31
Authors: Paul van Houtte, Albert Van Bael, Marc Seefeldt
Abstract:Finite element models for metal forming and models for the prediction of forming limit strains should be as accurate as possible, and hence...
13
Authors: Leo Kestens, Roumen H. Petrov
Abstract:The present paper presents an overview of present and future tools which can be used by the steel manufacturer in order to control the...
835
Authors: Paul van Houtte, Jerzy Gawad, Philip Eyckens, Albert van Bael, Giovanni Samaey, Dirk Roose
Chapter 1: Keynotes
Abstract:Cup drawing of sheet material (carbon steel DC06 and aluminium alloy AA3103-O) is simulated using a Finite Element (FE) method configured as...
26