Paper Title:
Plane Strain Compression of Single Crystalline Ni3Al-Base Intermetallic Compounds
  Abstract

Anisotropic deformation behavior of single crystalline Ni3Al-base intermetallic compounds, including Ni3Al single-phase and Ni/Ni3Al two-phase alloys, was systematically studied by the plane strain compression tests. Plastic flow behavior of single phase Ni3Al is strongly dependent on the initial crystal orientation and the flow stress becomes higher with increasing the numbers of the operative slip planes. In the case of the Ni/Ni3Al two phase alloys, the flow behavior is found to be divided into two stages. Such flow behavior is considered to be closely related to the difference in the deformation behavior between Ni solid solution and Ni3Al precipitates.

  Info
Periodical
Materials Science Forum (Volumes 495-497)
Edited by
Paul Van Houtte and Leo Kestens
Pages
767-774
DOI
10.4028/www.scientific.net/MSF.495-497.767
Citation
S.H. Song, K. Kishida, M. Demura, M. H. Oh, D. M. Wee, T. Hirano, "Plane Strain Compression of Single Crystalline Ni3Al-Base Intermetallic Compounds", Materials Science Forum, Vols. 495-497, pp. 767-774, 2005
Online since
September 2005
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Chang Liang Li, Hua Ding, Yong Qing Zhao, Lian Zhou
Abstract:Superplastic forming provides a good way for Ti alloys which are usually difficult to be deformed. Ti75 alloy with a nominal composition of...
2969
Authors: Zhi Guo Chen, Zi Qiao Zheng, Dong Feng Han
Abstract:The hot deformation behaviors and microstructure in Al-Cu-Li alloy containing small amount of Ag and Mg were investigated by transmission...
1925
Authors: Xiao Yu Zhong, Guang Jie Huang, Fang Fang He, Qing Liu
Abstract:Uni-axial tensile plastic deformation behavior of rolled magnesium alloy AZ31B under the temperature range from room temperature(RT) to 250°C...
219
Authors: Iram Raza Ahmad, Dong Wei Shu
Abstract:Magnesium alloys have been increasingly used in automobile, aerospace, consumer electronics and communication industries due to their low...
60
Authors: Tamás Mikó, Peter Barkoczy
Chapter 2: Plastic deformation
Abstract:This paper presents an investigation about the occurrence of the dynamic recrystallization (DRX) during hot forming. Two 7075 aluminum alloy...
105