Paper Title:
Dynamical Simulation Analysis and Experimental Study on a New Sugarcane Cutting Device
  Abstract

The cutting stiffness has notable influence on the sugarcane cutting quality, so great importance should be laid on enhancing the cutting stiffness when designing the cutting device. Based on cutting mechanism analysis, this paper proposes a new design of cutting device to increase the cutting stiffness by properly adding an auxiliary support bar and builds up 3D model of it. Then combining of virtual simulation analysis and physical experiment, it compares and analyzes the different stiffness and cutting quality with support bar in various support position or without it. The result shows that the new design with properly mounted support bar can raise 15.30% of the cutting stiffness, and consequently improve the sugarcane cutting quality distinctly.

  Info
Periodical
Materials Science Forum (Volumes 628-629)
Edited by
Dongming Guo, Jun Wang, Zhenyuan Jia, Renke Kang, Hang Gao, and Xuyue Wang
Pages
335-340
DOI
10.4028/www.scientific.net/MSF.628-629.335
Citation
X. Lai, S. P. Li, S. Liang, F.L. Ma, Z.Q. Cheng, X.B. Dai, "Dynamical Simulation Analysis and Experimental Study on a New Sugarcane Cutting Device", Materials Science Forum, Vols. 628-629, pp. 335-340, 2009
Online since
August 2009
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Jing Shu Hu, Hong Min Pen, Yu Wang, Tao Chen, Zhen Chang, Xian Li Liu
Abstract:Air cooling is a near dry machining method, which cools cutting area and evacuates chip using low temperature wind instead of cutting...
369
Authors: Jun Yong Xia, Wen Hong Ding, Zhang Yi Li
Abstract:Taking drum type flying shear as the subject, this paper firstly analyzes the position relation between shear blade and strip. Then it...
434
Authors: Zone Ching Lin, Jia Rong Ye
Abstract:This article presents a quasi-steady molecular statics nanocutting simulation model for simulating orthogonal two dimension cutting copper...
1357
Authors: Lai Xi Zhang, Xing Song Wang, Shu Lin Liu
Chapter 3: Functional Manufacturing and Information Technology
Abstract:A new 2-DOFs dynamic turning model including the compliance of workpiece and cutting tool is developed. In past studies, most of them were...
508
Authors: Mu Lan Wang, Yong Feng, Xiao Xia Li, Bao Sheng Wang
Chapter 4: Fluid Mechanics and Thermodynamics
Abstract:An experimental system used for temperature measurement is designed by the K-type thermocouple thermometry to achieve a direct measurement of...
594