Paper Title:
Texture Change of Severe Plastically Deformed Al Alloy Sheets
  Abstract

Aluminum alloy sheets have lower formability (r-value) than low carbon steel sheets in fully annealed condition. Because the texture of fully annealed aluminum alloy sheet is mainly consists of cube component {001}<100>, which shows low formability. Asymmetric rolling, one of the severe plastic deformations, gives rise to shear deformation texture through the Al sheet thickness. In this paper, the changes of texture components after the severe deformation and subsequent heat treatment in Al sheet were observed. The change of the formability after the severe plastic deformation and subsequent heat-treated Al sheets have been analyzed with the change of texture of Al alloy sheets.

  Info
Periodical
Materials Science Forum (Volumes 654-656)
Main Theme
Edited by
Jian-Feng Nie and Allan Morton
Pages
1259-1262
DOI
10.4028/www.scientific.net/MSF.654-656.1259
Citation
I. S. Kim, S. K. Nam, S. Akramov, "Texture Change of Severe Plastically Deformed Al Alloy Sheets", Materials Science Forum, Vols. 654-656, pp. 1259-1262, 2010
Online since
June 2010
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: N. R. Ha, Z. X. Yang, Kyu Hong Hwang, J. K. Lee
Abstract:Pure Titanium alloys are superiorities of biocompatibility, mechanical properties and chemical stability. The biocompatibility of Ti alloy...
177
Authors: Cui Li, Wei Qi, Kutsuna Muneharu
Abstract:A zircon coating was applied on the surface of Ti-6Al-4V alloy by plasma spray and its effect on the high temperature tensile properties of...
547
Authors: Zhen Tao Yu, Gui Wang, Xi Qun Ma, Matthew S. Dargusch, Jian Ye Han, Sen Yu
Abstract:The effects of alloy chemistry and heat treatment on the microstructure and mechanical properties of Ti-Nb-Zr-Mo-Sn near  type titanium...
303
Authors: Cui Fang Duan, Wei Li, Ji Liang Zhang
Chapter 4: Material Engineering and its Application Technology
Abstract:This article studies aluminum alloy plate through 16 to 3mm thick with a hole under room temperature fracture test. The experimental results...
315
Authors: Xin Wu Ma, Guo Qun Zhao, Wen Juan Li
Chapter 5: Materials Processing and Chemical Technologies
Abstract:A new method for determination of friction coefficient in sheet metal forming of Mg alloy AZ31B is presented in this paper. The method is...
430