Paper Title:
Key Microstructural Changes during High Strain Rate Superplastic Deformaion of an Al-Zn-Mg-Cu-Zr Alloy Containing Sc
  Abstract

The changes in texture and microstructure that occur during superplastic deformation (SPD) of a suitably thermo-mechanically processed (TMP) Al alloy AA7010 containing Sc at a temperature and strain rate combination of 475°C, 1.9x10-2s-1 have been examined. It is observed that during the early stages of SPD, there is a significant increase in the Brass {110}<112> component as well as a considerable increase in the S {123}<634> component. Whilst, these components gradually decrease leading to the randomization of texture as the SPD process progresses to larger strains. These results are discussed in terms of the nature of the TMP together with significant variations in the number density of Al3ScxZr1-x dispersoids and percentage recrystallization with strain.

  Info
Periodical
Materials Science Forum (Volumes 702-703)
Chapter
Chapter 2: Deformation
Edited by
Asim Tewari, Satyam Suwas, Dinesh Srivastava, Indradev Samajdar and Arunansu Haldar
Pages
366-369
DOI
10.4028/www.scientific.net/MSF.702-703.366
Citation
A.K. Mukhopadhyay, A. Kumar, K.S. Prasad, S. Raveendra, I. Samajdar, "Key Microstructural Changes during High Strain Rate Superplastic Deformaion of an Al-Zn-Mg-Cu-Zr Alloy Containing Sc", Materials Science Forum, Vols. 702-703, pp. 366-369, 2012
Online since
December 2011
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: A.K. Mukhopadhyay, K. Satya Prasad, A. Dutta
Abstract:The influence of Sc addition on the high temperature compressive strength of a commercial alloy 7010 (hereafter termed base alloy) has been...
871
Authors: Ali Reza Eivani, H. Ahmed, Jie Zhou, Jurek Duczczyk
Abstract:Four variants of AA7020 aluminum alloy having different Zr and Cr contents were investigated aiming at reaching high recrystallization...
177
Authors: Alla Kipelova, Ilya Nikulin, Sergey Malopheyev, Rustam Kaibyshev
Abstract:Microstructural changes during equal channel angular pressing (ECAP) at the temperatures of 250 and 300°C to the strains ~4, ~8 and ~12 were...
487
Authors: Ilya Nikulin, Alla Kipelova, Rustam Kaibyshev
V. Processing
Abstract:An ultra-fine grained structure with an average size of ~ 1 μm was produced in a commercial Al–5.4%Mg–0.5%Mn–0.1%Zr–0.12%Si–0.014%Fe alloy by...
347