Paper Title:
Three Rollers – Cone Test. New Possibilities of Wear Calculation
  Abstract

In tests presented in the paper the authors made use of M.M. Chruščov’s concept of determining linear wear intensity Ih in model systems operating under constant load in which the contact stresses decrease in the effect of wear. They elaborated the mathematical model binding vertical approach of samples in four ball apparatus equipped with the three rollers – cone couple with rollers wear trace dimension. The model was verified in the special experiment obtaining a very good convergence of results of calculations and the experiment.

  Info
Periodical
Solid State Phenomena (Volume 113)
Edited by
Nin Bizys, Andrejus Henrikas Marcinkevicius
Pages
363-366
DOI
10.4028/www.scientific.net/SSP.113.363
Citation
W. Zwierzycki, T. Rochatka, "Three Rollers – Cone Test. New Possibilities of Wear Calculation", Solid State Phenomena, Vol. 113, pp. 363-366, 2006
Online since
June 2006
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Xin Tao Xia, Ya Ping Zhang, Yong Zhen Zhang, Shi Chao Chen
Abstract:The experiment on the friction and wear of the lithium grease is done by choosing the ZrO2 nanoparticles as the additive in order to study...
83
Authors: Yong Xing Tong, Li Qin Wang, Le Gu, Bo Peng
Abstract:The friction and wear behavior of Si3N4, SiC and ZrO2 sliding against M50 bearing steel under vacuum...
973
Authors: Daniel M. Mulvihill, Mehmet E. Kartal, David Nowell, Dawid A. Hills
Abstract:Many researchers that have carried out fretting wear tests have presented results which show a variation (usually an increase) in the...
213
Authors: Windarta, M. Bin Sudin
Chapter 14: Modeling, Analysis, and Simulation of Manufacturing Processes
Abstract:The interaction between wheel-rail produced defects on each other. Many studies of wear were done using pin-on-disc tribometer on interaction...
2406
Authors: Marcin Gołąbczak, Philippe Jacquet, Corinne Nouveau, Romain Fliti
Abstract:X38CrMoV5-1 steel is a typical tool steel commonly used in forging and plastic moulding industry for production of ejectors, slides, dies,...
97