Paper Title:
Assessment of Dynamical Properties of Die Hammer MPM 10000 B Considering Deformations of Working Material
  Abstract

This paper presents an assessment of dynamic properties of a die hammer. The object of research is the steam-air die hammer MPM 10000 B that is considered taking into account the deformations of the working material. Based upon the technical specifications, two calculation models of the hammer were developed assuring the proper selection of the parameters. Next, the numerical simulations were performed, which results were presented in a graphical form as time histories of displacements and accelerations of particular elements of the hammer. It was demonstrated that the analyzed design of a die hammer has sufficiently low level of vibration amplitudes as well as their accelerations.

  Info
Periodical
Solid State Phenomena (Volume 144)
Edited by
Inga Skiedraite and Jolanta Baskutiene
Pages
71-76
DOI
10.4028/www.scientific.net/SSP.144.71
Citation
L. Majewski, A. Trąbka, "Assessment of Dynamical Properties of Die Hammer MPM 10000 B Considering Deformations of Working Material", Solid State Phenomena, Vol. 144, pp. 71-76, 2009
Online since
September 2008
Export
Price
$32.00
Share

In order to see related information, you need to Login.

In order to see related information, you need to Login.

Authors: Shi Cheng Xiao, L.P. Zhang, Li Yong Ni, Wen Hua Yang, H.L. Liu
Abstract:Research was conducted for stretching with horizontal V-shaped anvils (HVA) and common flat anvils (FA). The forgoing research gave the...
611
Authors: Li Yong Ni, Suo Qing Yu, L. Li, S.Y. Zhu, Hua Gui Huang
Abstract:High transversal properties requirements of heavy axial forgings, traditionally, often are met through the selection of high-performance...
113
Authors: Yong Hua Li, Jing Zhang
Chapter 9: CAM/CAE
Abstract:The upsetting process of cylindrical forging was investigated using finite element method. The influence of conical anvil on deformation rule...
1870
Authors: Tso Liang Teng, Cho Chung Liang, Chien Jong Shih, Van Hai Nguyen
Chapter 3: Modeling, Analysis and Simulation
Abstract:Bike helmets must meet minimum standards of construction and materials design. This paper focuses on assessment of a helmet based on the...
744
Authors: Yong Hua Li, Jing Zhang, Wei Yi Liu
Chapter 2: Research on Materials,Mechanics and Technologies
Abstract:Stretching is a commonly used process to manufacture forgings with good quality. In this paper, the stretching process of cylinder forging...
91