Papers by keyword «Turning»
-
Residual Stresses due to Hard-Machining - Industrial Experiences
Authors: Peter Vomacka, Hartmut Walburger
Keywords: Case Hardened Steel, Grinding, Machining, Peak Width, Residual Stress, Turning
-
Green Machining of Alumina
Authors: H.R. Maier, N. Michaeli
Keywords: Aluminium, Green Machining, Turning
-
Performance and Applications of CVD Thin Film Diamond Coated Tools
Authors: Chi-Hung Shen
Keywords: 390 Aluminum, Abrasive Wear , Adhesion Strength, Carbide Substrate, Chemical Vapor Deposition (CVD), Drilling, Film Delamination, Flank Wear, Flymilling, Metal Matrix Composite (MMC), Polycrystalline Diamond, Surface Roughness, Thin Film, Tool Life, Turning
-
Experimental Determination of Rake Face Stress Distributions
Authors: D.E. Buryta, R. Sowerby
Keywords: Brass, Carbide, Machining, Rake Face Stresses, Steel, Turning
-
Factors Affecting the Machinability of Al/SiC Metal-Matrix Composites
Authors: John Monaghan
Keywords: Drilling, Electro Discharge Machining (EDM), Machinability, Surface Integrity, Tool Materials, Tool Wear, Turning
-
Sintering Properties and Cutting-Tool Performance of Ti(C,N)-Based Ceramics
Authors: Tadahiko Watanabe, Tsuyoshi Doutsu, Tsutomu Nakanishi
Keywords: Al2O3, B4C, Ceramic Tool, Chipping, Cr3C2, Cutting Tools, Failure, Metal Carbide, Ti(C,N)-Cr3C2, Ti(C,N)-TiB2, Ti(C,N,), TiB2, Tool Life, Tool Performance, Tool Wear, Turning, ZrO2
-
Ceramic-Coated Cutting Tools
Authors: Shinsaku Hanasaki, Junsuke Fujiwara
Keywords: Ceramic Coated Tool, Cutting, High Nickel Alloy, Tool Life, Tool Wear, Turning
-
Influence of Machining on Residual Stresses and Properties of Superhigh Strength B96ц Thin Elements
Authors: O.G. Senatorova, I.N. Fridlyander
Keywords: Creep, Mechanical Property, Relaxation, Residual Stress, Surface Hardening, Turning
-
Turning of CFRC Composites Using Si3N4 and Thin CVD Diamond Coated Si3N4 Tools
Authors: Manuel Belmonte, Filipe J. Oliveira, M.A. Lanna, C.R.M. Silva, Evaldo J. Corat, Rui F. Silva
Keywords: Carbon Fibre Reinforced Carbon Composites, Cutting Force, CVD Diamond Tool, Turning
-
Depth Profile of Titanium Alloy (Ti-6Al-4V) and Residual Stress Measured by Using X-Ray Diffraction after Metal Cutting Assisted by High-Pressured Jet Cooling Evaluation of Etching Methods: ION Beam (EDOS) and Electro-Chemical Etching
Authors: Manoucheh Vosough, Ping Liu, Inge Svenningsson
Keywords: Aerospace Material, Residual Stress, Titanium (Ti-6Al-4V), Turning, X-Ray Diffraction (XRD)
|
Next 10 Keywords
|
